Valve seal issues.

**Hi-Po** · 03-23-2009, 11:31 AM

When I pulled on the intake side, the whole seat came out with the seal. The exhaust side, just the seal came out and that is the seal shown below. The one on left.

Does the new seal go in from the bottom like this?

Here is the old seal and new seal. Old is on the Left and new is on the Right.

Anyone help me? Im trying to get these springs replaced, tomorrow im getting yet another set of PR's and wanna get this done. Thanks guys.

It seems to me I got shipped 16 seals, all the same. I think I need the different exhuast seal. Whats going on here? Thanks.

**Hi-Po** · 03-23-2009, 11:45 AM

Basically, Im wondering if I need 2 different seals for intake and exhaust. LS1howto says there are two different seals, and everything I have ever read say there are two different seals.

The seal on the right is what I have 16 of. Can I use those for both intake and exhaust? The new seal does not want to go on the guide, do I just need to put a deep well socket and give it a little tap?

**shady milkman** · 03-23-2009, 11:52 AM

damn ron your having a hell of a time

i feel bad for ya homey

**Hi-Po** · 03-23-2009, 11:54 AM

Eh, the Push rod thing was my fault. I should have taken them out before ordering them. They will be here tomorrow, but this valve seal thing is stumping me. I dont wanna put the wrong seal in there.