Need advise..

[full_360]

hey guys i have question. I'm currently swapping out my aftermarket cam to install my stock cam back into the engine. My question is that i have the double valve springs from TPIS and their hardened push rods.... can i use the stock push rods with those springs and or can i use the hardened push rods with the stock cam????? my car has the LS1 in it...

[mark21742]

Did the aftermarket cam use the same lenght pushrods as the stock one? If I were you, I'd leave the double springs and run the hardened pushrods

[Z28boy2000]

id leave them both, as long as the rods are the same length as the stockers

[xmarkx]

you can leave the springs for sure but most likely you will have to put in the stock pushrods unless they are the same size as stock.

what's your reason for going back to stock? (just wondering)

[full_360]

Sorry for the late response. The reason why I'm pulling the cam out is because I'm leaving out of town and I'm taking my car. I don't want any problems since its going to be my daily driver for a while. Thanks for the replies guys!!