Results 1 to 5 of 5
Thread: ms3 cam
-
12-20-2009, 05:00 PM #1
ms3 cam
If MS3 and MS4 are very good cams for mid to high end power what would be an awsome cam for low to mid end torque and deathly loud and shaky? This would be on a car that has ported heads and a steep gear.
-
12-20-2009, 05:50 PM #2
le custom cam from what if been told!
**removed non-sponsor link**Last edited by 0rion; 12-22-2009 at 11:43 AM.
02 ws6,m6,umi sfc, bbk lt's,y pipe,stainless borla straight pipew/dynomax bullet,160 stat,4.10's,umi adj trq arm,k&n,sportlines,kyb agx's,98mm clear lid,all free mods,d-scrnd mass,fernco,e3 plugs,short stick,tunedbyfrost,no hood baffles,hood to air box w/adh. foam,needs a cam
-
12-24-2009, 05:54 PM #3
What do you guys think of the torquer v3?
-
12-27-2009, 03:44 PM #4
good cam IMO. hasnt been as proven as say the torquer v.2 or the 233/239 but i think its still a good cam.
-
12-31-2009, 08:14 AM #5
- Join Date
- Oct 2007
- Location
- NC
- Posts
- 635
SOM- 1998 T.A.
The tv 3 is a nice cam but I don't like the .643 lift on the intake side. If you are gonna drive it much you will need to change springs fairly often. The tv 2 has 598 I/E lift and will be easier on springs and I doubt there is 5 rwhp difference between them.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks