Results 1 to 2 of 2
Thread: gear drive
-
03-18-2008, 08:50 PM #1
- Join Date
- Dec 2007
- Location
- spokane
- Posts
- 3
gear drive
well this has nothing to do with an LS series engine but i have a small block 350 and rebuilding it, .030 over and .020 on mains and rods. i'm building the engine for my jeep rock crawler. I have decided to go with a gear drive timing set up, i'm looking into one. are they hard to install/? or they just like a chain? some were i was reading you have to grind some of the block to fit some gear drives in.
-
03-18-2008, 09:38 PM #2
If memory serves some kits did have lceance issues with some castings. As for ease of install yeap pretty much llike a chain I would think.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Gear drive for ls1
By 99formulals1 in forum Internal EngineReplies: 4Last Post: 11-29-2008, 04:04 AM -
2002 Camaro ss a4 Help! redlines a gear then changes a gear from a roll please read!
By hmorris7000 in forum General HelpReplies: 9Last Post: 06-01-2007, 05:18 PM -
Is it bad to drive in third gear?
By REDBEAST in forum Automatic TransmissionReplies: 6Last Post: 10-27-2006, 05:56 PM -
1969 chevelle ss 396 new 396 w/noisy gear drive , a cruiser , a racer , you decide
By ray wagers jr in forum Classic MuscleReplies: 0Last Post: 07-19-2006, 10:57 PM -
gear drive question?
By roadrashr6 in forum Camaro / SSReplies: 0Last Post: 02-09-2006, 08:20 PM
Bookmarks