Results 1 to 2 of 2
Thread: Setting Pinion Angle
-
02-07-2006, 02:44 PM #1
- Join Date
- Jan 2006
- Location
- New Orleans, LA
- Posts
- 53
Red- '01 Trans Am WS.6
Setting Pinion Angle
I've seen the desired pinion angle expressed in two different ways for an '01 T/A; either as (-2) degrees or (+2) degrees. I'm assuming that we want the pinion at an inclined position (tilted upward) in relationship to the drive shaft. Is this correct? And, is this referred to as a (+) of (-) angle?
-
02-08-2006, 02:31 PM #2
no, you want the pinion to be downward from the driveshaft. that would be in the negative arragement. that way, when you accelerate, the pinion tries to climb up the ring gear. this will make for a 0* angle when accelerating.
Cold Air Intake, Muffler Delete, Vinci High Performance Dual Valve Springs, Hardened Pushrods, Yella Terra 1.85 Rockers, Some Hydropdipped Stuff, Strut Tower Brace, Some SS Badges, boost/vacuum gauge, fuel pressure gauge, some checkered stripes, drilled/slotted rotors, ZL1addons Stealth wickerbill, Ruxifey LED side markers
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
setting proper u-joint and pinion angle
By mrr23 in forum Suspension and HandlingReplies: 13Last Post: 09-19-2009, 05:50 PM -
setting pinion angle
By ls14gezr in forum DrivetrainReplies: 1Last Post: 02-10-2007, 06:04 PM -
pinion angle help please
By shawn2002z28 in forum DrivetrainReplies: 22Last Post: 04-10-2006, 01:58 PM -
Pinion angle setting for spohn torqe arm
By sparkey in forum Suspension and HandlingReplies: 3Last Post: 11-17-2005, 09:02 PM -
Help with pinion angle
By JGA in forum Suspension and HandlingReplies: 0Last Post: 10-15-2005, 04:56 PM
Bookmarks