Results 1 to 20 of 29
-
05-20-2007, 12:07 PM #1
Do you hit 4th gear when drag racing?
I was just wondering who shifts into 4th and who leaves it in 3rd when drag racing?
I always leave it in 3rd and hit the rev limiter about 25ft before the finish line. I cross the line at about 101-102mph.
My friend with an SS shifts his into 4th and he crosses the line at about the same speed.
My car is stock and I ran a 13.700. but my friend has lt's and exaust, plus free mods. He ran a 13.5.
-
05-20-2007, 12:25 PM #2
I am right around the redline (6000) in 4th on a 1/4, but then again I have 4.11s. Don't tell your friend and throw 4.11s in the rear and have fun with him...LOL. 4.11s are perfect for drag racing, in the 1/8th you are at top of third and in 1/4th you are at top of 4th.
-
05-21-2007, 11:40 AM #3
- Join Date
- Feb 2007
- Location
- Bakersfield, CA
- Age
- 42
- Posts
- 548
86 Buick Grand National- 02 WS6-M6 407 RWHP
I'm gonna put 4.10's in mine but what will i top out at in 4th at 6400 rpms.
-
05-21-2007, 12:47 PM #4
- Join Date
- Sep 2005
- Location
- New York, NY
- Posts
- 1,718
Collectors Edition Yellow- 2002 Pontiac Trans AM WS6
I have 4.10's in mine and a raised redline so im topped out at 6500 in 4th and if i get a good launch ill shift to 5th
-
05-21-2007, 02:05 PM #5
- Join Date
- Feb 2007
- Location
- Bakersfield, CA
- Age
- 42
- Posts
- 548
86 Buick Grand National- 02 WS6-M6 407 RWHP
what are your mph's at ? If i have high 11 second car am i gonna have to shift to fifth.
-
05-21-2007, 02:33 PM #6
here you go this is 4.10/.11 only have it set to 6700 cause that is where my rev limiter is set to.
5800 41 61 83 108 146 215
5900 41 62 84 110 148 219
6000 42 63 86 111 151 223
6100 43 64 87 113 153 227
6200 43 65 89 115 156 230
6300 44 66 90 117 158 234
6400 45 67 91 119 161 238
6500 45 68 93 121 163 241
6600 46 69 94 123 166 245
6700 47 70 96 124 168 249
and for those still with 3.42s,
5800 49 73 100 129 175 259
5900 50 74 101 132 178 263
6000 50 75 103 134 181 268
6100 51 76 105 136 184 272
6200 52 78 106 138 187 277
6300 53 79 108 141 190 281
6400 54 80 110 143 193 286
6500 55 82 112 145 196 290
6600 55 83 113 147 199 295
6700 56 84 115 150 202 299
if you want any other than here is the site:
http://www.f-body.org/gears/
the highest it goes is 98 for us, but it didn't change from 98. change the gear ratio to see what gears would do for you and would suit you best.
-
05-21-2007, 03:18 PM #7
- Join Date
- Feb 2007
- Location
- Bakersfield, CA
- Age
- 42
- Posts
- 548
86 Buick Grand National- 02 WS6-M6 407 RWHP
thanks man
-
05-21-2007, 03:34 PM #8
- Join Date
- Sep 2005
- Location
- New York, NY
- Posts
- 1,718
Collectors Edition Yellow- 2002 Pontiac Trans AM WS6
Do whats more practical to you, 4.10s/11 is going to have you on and off the clutch quickly when driving around town...Personally i love my 4.10's and i have well over 400RWHP/TQ but it all depends on yourself...And like with any aftermarket gear your bound to get rear whining...I get a tad around 55-65 but im fine other then that...Make sure who ever sets up your rear gears KNOWS what there doing!!!
-
05-21-2007, 05:15 PM #9
NeeD4SpeeD, yours whines. I've heard that alot from ppl, I am over the 400 marker myself and I have no noise. Then again, maybe my mechanic was more strict on DO's and DON'Ts. I put around 550 miles mostly city, and did at least 15 cool down cycles (at least 2 hours cool down time)in the process. I never once got on the gas until I completed that break in cycle that he recommended. And it sucked, I wanted to check out the new gears right away, the temptation was great but I overcame it.......LOL.
Also, what brand gears did you get. I got GM.
-
05-21-2007, 05:18 PM #10
-
05-21-2007, 06:06 PM #11
Ok, let me rephrase the Question...
Do you hit 4th gear when drag racing, and still have stock 3.42 gears?
-
05-21-2007, 06:08 PM #12
oh, and I am thinking about getting a tuner soon (few months), what is a safe spot to set the rev limiter to? I have a stock motor and I don't want to blow it up, but I still want to push it a little past 6,000rpm's.
-
05-21-2007, 07:17 PM #13
- Join Date
- Sep 2005
- Location
- New York, NY
- Posts
- 1,718
Collectors Edition Yellow- 2002 Pontiac Trans AM WS6
See i got motive which i specifically heard gets no whine... But mine does just a bit and i took the cover off and personally checked the heel and tow and pinion angle and tested the wear pattern and its textbook perfect so im guessing its the motive gears...I think i should have went with the gm gears but oh well mayb when i switch to the 9 bolt...And i did all the cool down cycles like you and i dont put nearly as much miles as u do...cuz i have a beater i drive 2 and from work so im lucky if i put 2K miles a year on my ws6...But u like the gm gears and do you have a 12" or 9" or a stocker rear for thoes gears?
-
05-21-2007, 08:21 PM #14
Ryanater, yes when I did have 3.42s I did go into 4th, very close to the end of 1/4. I don't like taking the chance of bouncing off the rev. limiter. Also if you get a tuner, I personally would not suggest raising the limiter, it is set to 6000 stock for a reason. Any higher and you start to chance valve float. Upgrade your valvetrain if you want to go any higher would be my suggestion. And of course throw a good cam in there..haha.
-
05-21-2007, 08:29 PM #15
NeeD4SpeeD, yeah I just bought me a beater (for work ONLY) lol...woohoo. But I will still put miles on mine, I bought it to enjoy it and don't plan on selling it, ever, so mileage doesn't really matter to me. Yeah I still have the stocker rear end. Once I do full suspension I think I will go with a 9" with GM gears. But yeah my mechanic told me GM is about the best actually out there for gears.
-
05-21-2007, 08:56 PM #16
-
05-21-2007, 09:05 PM #17
hmmm, good question, maybe shift a little prematurally. You would still end up in your power band anyways.
-
05-21-2007, 09:07 PM #18
Anyone else have this problem???
-
05-22-2007, 04:31 AM #19
It looks like right now, you're right at the point where there isn't going to make much of a difference even if you shift into fourth. You're running a 13.7 and trapping right around 102 - 103 (the third gear redline). That being said, if you start to mod your car (even some of the more basic mods such as exhaust, cai, etc.) you should expect to trap higher and there would no longer be a benefit to hanging in third gear for the last part of the quarter mile. If you really want to make it fun, slap a set of 3.90's or 4.11's in there and that will keep drive you well into the powerband in 4th gear.
-
05-26-2007, 03:18 PM #20
I just went to the track last night and aswered my own question. YES, shift to 4th. My trap speed went up 2mph. I also ran .3 sec faster.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Drag Racing 101
By ss_caramo in forum Drag RacingReplies: 31Last Post: 05-19-2020, 09:27 AM -
Drag Racing
By andersonsmith125 in forum Drag RacingReplies: 0Last Post: 10-12-2011, 09:53 PM -
Question: drag racing help?
By SSIZZLN in forum Drag RacingReplies: 3Last Post: 10-22-2010, 02:49 AM -
Drag racing ?
By Lawnman in forum Drag RacingReplies: 9Last Post: 05-10-2007, 06:02 PM -
Think you know Drag Racing?
By skeet38 in forum Drag RacingReplies: 1Last Post: 04-25-2007, 07:09 AM
Bookmarks