Results 1 to 3 of 3
Thread: Can't disconnect hose at trans.
-
02-17-2007, 11:06 AM #1
Can't disconnect hose at trans.
I'm trying to change my clutch master cylinder, and I can't get the line disconnected from the trans. I've pushed the white clip all the way flush with the slave cylinder hole, but it still won't pull out. I'm at my whits end! Also, what size is the bleeder screw above the line. Thanks.
-
02-18-2007, 04:55 AM #2
- Join Date
- Nov 2006
- Location
- Earth
- Posts
- 215
There's a line disconnect tool available - if you haven't already used it. It is simply a fork that slips into the groove that releases the connector. The only one they had at the time at AutoZone rental ($5) was one for a ford. It fit a little tight but still worked easily.
As for the bleeder, I've not had to use it but 10 mm is what I would first think.
-
02-18-2007, 11:31 AM #3
I finally got it loose. Had to push in on the hose a little, push the white clip flush and then into the groove a little all the way around. Then pulled, and it came out. Install university said to push the clip and it would pop out, mine did not. The bleeder screw was a 12mm.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Trans Am WS6 Seat Lumbar hose
By aerojt in forum Firebird / WS6Replies: 3Last Post: 02-08-2016, 03:51 PM -
I cant disconnect the fuel line
By freddy_caprice in forum External EngineReplies: 7Last Post: 06-09-2011, 09:49 AM -
Help: Can't get quick disconnect in slave cy!!!
By z28tito in forum Manual TransmissionReplies: 1Last Post: 12-13-2009, 07:56 AM -
EGR AIR disconnect
By roadracetransam in forum External EngineReplies: 2Last Post: 03-07-2006, 07:58 AM -
EGR AIR disconnect
By roadracetransam in forum External EngineReplies: 0Last Post: 03-06-2006, 11:50 PM
Bookmarks