SLP LS6 intake

**Camaro98Z/28** · 08-10-2009, 09:55 AM

I have a 98 Z28
I am buying a SLP LS6 intake to keept the EGR
however it states that cutting of the egr must be done for it to fit
i have no problem doing that but how does it actually bolt down to the intake after the cut is made?

thanks!

**flipsutter** · 08-10-2009, 10:26 AM

Well, when they say cut you are not cutting the hose or connector.

Not sure I will get in trouble linking this but I'm going to do it.
http://www.installuniversity.com/ins...r_free_mod.htm

As you can see you are cutting the metal part that sticks into the intake and not where you bolt it down.

At least that's what I think they are requiring you to do so it will fit.

**Marc 85Z28** · 08-11-2009, 06:18 AM

Originally Posted by Camaro98Z/28

I have a 98 Z28
I am buying a SLP LS6 intake to keept the EGR
however it states that cutting of the egr must be done for it to fit
i have no problem doing that but how does it actually bolt down to the intake after the cut is made?

thanks!

It doesn't bolt down. It uses a SwageLok fitting. Install instructions are on SLPs site. Good luck too, because holding the bottom part of the fitting when torquing is a huge PITA.