Series 10 (1 chamber) Flowmasters

TP121 · 07-19-2006, 07:32 AM

Anyone have a sound clip of their car with this setup?

I have read many good things about the 1 chamber sound and flow.

Thinking about using these with QTP headers, cats, and 2.5" pipe into a CME.

**Zboner** · 07-19-2006, 07:39 AM

yes, go to the sticky made in the external engine section about this, i run a true dual system with the 1 chambers, i run a 3" off pacesetters, into an X pipe that dumps before the axle. no cats at all. quiets it down a little much but i love the sound, u can check out LS1sounds.com for the sounds, ill have mine up soon

TP121 · 07-19-2006, 11:13 AM

Originally Posted by Zboner

yes, go to the sticky made in the external engine section about this, i run a true dual system with the 1 chambers, i run a 3" off pacesetters, into an X pipe that dumps before the axle. no cats at all. quiets it down a little much but i love the sound, u can check out LS1sounds.com for the sounds, ill have mine up soon

Appreciate the info.

I will run cats on mine, just because I'm not going to lose much, if any hp and it should take out any roughness in the sound.

I'm looking for clips of an exhaust thats not dumped- its very difficult to imagine what the exhaust would sound like exiting at the rear or my CME setup. But, I will appreciate the sound clips either way- at least its a start.

**Zboner** · 07-19-2006, 11:25 AM

yea it is, i would like to get some pictures of it so when i run mine out back, my buddys car is in the sticky up there running out the rear, it should sounds pretty close exiting out the rear of the car, but maybe a bit louder since it is not bouncing off the ground, anyways u will love the sound i love mine right now