"Miss" me off......

[suede]

So i got a really bad miss all of a sudden, but i'm fairly sure headers melted a plug wire. The question is- anyone know where i can get new wires with the fiberglass heat shields, or an equivelant? Lookin @plugs too while im at it... suggestions?

[sunsetorangess]

Pick up some wires, Brand depends on what you want. Heres a sticky:
http://www.ls1.com/forums/showthread.php?t=31657
I would go with some NGK plugs
You can pick up some Accel Fiberglass head shields that slide over your wires. Iv been using them for years with no issues or melted wires. Only cost about 40 bucks.
J

[suede]

Well i found a MSd 8.5 and NGK TR55 8-pk combo for 70 bucks so im liking the looks of that, but i found the accel wire covers, and two questions..... Do they fit over the end of the plugs or do you haveto do the whole cut the end of bs? Second, why do they only sell it in 25 ft spools?

[sunsetorangess]

Ok were not on the same page, heres what i used and im refering to.
Accel / Spark Plug Fiberglass Boot, I sent you a pm with a link.
They just slip over the boot and wire, no cutting.
J

[OnEbAdReDSS]

i got msd's they hold up to my lt's well and my lt's are the non coated... only one of them i put heat wrap on..