FAST 92mm Intake

**Bouvers** · 09-25-2008, 08:46 PM

A couple of questions about the FAST 92 can't seem to find anything in the search.

question 1- what is required when you paint a FAST intake? I want a smooth finish and not textured. Is there sanding involved? What is the best paint to use for the job? Does it have to be for a certain heat level?

question 2- What is all involved when porting a FAST 92? I've yet to see a write up for it. Any help is appreciated...

**mark21742** · 09-27-2008, 09:24 AM

as far as painting it goes, to get a good smooth finish that you want, you need to to do Alot of hand sanding and get the plastic nice and smooth to your liking before you paint it. you might not need it but, id go with a high temp paint to be safe.... id hate to go through all the work to get it the way you want it, then have the paint peel because it got alittle hot

Ive honestly never seen a fast intake in person, but if you have all your gaskets id just smooth and match the ports to them

**Hi-Po** · 09-28-2008, 08:49 AM

Try a quick search next time. Its a great feature.
http://www.ls1.com/forums/showthread...=painting+fast

**Bouvers** · 09-28-2008, 12:39 PM

good call but I did try a search on here because I figured this would be the obvious place to find it... I later searched the "appearance section" and found that thread....

thanks though.