Cutout Location

[00Formula00]

Im about to install a whole new exhaust everything (LT's, Catted Y, SLP LM II)

My Question is where to put the cutout(s)

Right after the headers, but that means i have to weld the cutouts right on the headers right? or can i get clamps or something besides welding..

Otherwise i would put one cutout behind the ypipe, but i have a buddy who says putting a cutout that far back won't sound any different, i think thats bullshit

What's everyone think/ sugest?

[Zboner]

if your doning one then at the I pipe if two then after the headers, on the Y pipe so it runs straight out

[NHRAMAN]

most who have 1 cutout, put it under the rear passenger seat....there is an indentation there that it tucks up into...almost like it was made for it.....if 2 are in your plan...6-8 inches back from the collector or somewhere there...a friend put his 8" back...sounds wicked.

[00Formula00]

so if i got two then i would weld the directly onto the headers, or a ways down but still before the y pipe joins?

[NHRAMAN]

noooo...put the cutout pipe on the Y part..NOT welded to the headers...

[Zboner]

dont weld them on there, get the flanges on the headers to bolt to the pipe, then 6-8" back on the Y pipe after the headers

[00Formula00]

MUSTANG FRIENDS ARE DUMB AS SHIT

[00Formula00]

by the way will two at that position be significantly louder than one at the end of the ypipe