Wiring Question

[t/as&dds]

I was swapping out my tranny mount the other day and while I had the crossmember off, I noticed that the passenger side O2 sensor wiring was just kind of hanging there. I know that it's not supposed to because it has a little nib on the end that should plug into a hole in the floorpan or something but I can't see or feel where it should go. I rubbed the whole bottom of the car on that side and couldn't find a hole to plug it in to. Right now I've got that blue aluminum tag on the trans holding in place. It's not in danger of getting cooked or anything but it doesn't belong like that I'm sure. Any ideas???

Thanx

[lawdog]

plugs into a hole on the upper part of the tranny housing.

[sonnyred]

Could it be the cags connecter?

[MadSeason]

Are you throwing a code?

[t/as&dds]

Nope, it's the passenger side O2 connector, I can see where it goes but it's just hanging there which isn't right. No code is being thrown either, everything's connected fine, I just don't want it getting cooked on the exhaust or something.

Thanx

[MadSeason]

if you can't tie it up away from the exhaust buy a little header wrap and put it around the area so the wires dont get cooked