Results 1 to 6 of 6
-
09-19-2009, 01:08 PM #1
- Join Date
- Feb 2007
- Location
- canada
- Posts
- 11
pewter- 2001 WS6 T/A
max cubes from a gen 3 6.0 iron block?
have two 6.0 L gen 3 engines sitting in my shop,just wondering if any body has built one up and how big you can go?
-
09-21-2009, 01:35 AM #2
safly I'd say 427, but I know a guy building 500+ aluminum ls1 with deck plates, long sleeve stroker, sheet metal intake and twin 90mm TBs.......how much money do you to spend?
-
09-21-2009, 06:30 AM #3
- Join Date
- Feb 2007
- Location
- canada
- Posts
- 11
pewter- 2001 WS6 T/A
have not thought about cost yet,I know forged bottom end will be a must.
looking to build 700 to 800 hp for a mud rail car. uit should be under 1900lbs
when finished.
-
09-21-2009, 07:36 AM #4
-
09-21-2009, 08:09 AM #5
-
09-21-2009, 08:33 AM #6
- Join Date
- Feb 2007
- Location
- canada
- Posts
- 11
pewter- 2001 WS6 T/A
have lots of nitrous at my shop, still touing with turbo ideas.
still looking for a good place to purchase turbo components.
mostly diesel stuff around here
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Question: 6.0 Iron Block
By 98formy in forum General HelpReplies: 6Last Post: 06-09-2008, 04:41 AM -
6.0 iron block???
By OreoLt1 in forum Forced InductionReplies: 9Last Post: 12-19-2007, 03:36 PM -
396 Cubes from a 99 LS1 block?
By Roastem in forum Internal EngineReplies: 0Last Post: 05-02-2006, 10:43 AM
Bookmarks