Results 1 to 10 of 10
Thread: Knock Sensor ?
-
11-03-2007, 07:47 AM #1
Knock Sensor ?
Where is it located? I'm getting a po327 code
-
11-03-2007, 08:03 AM #2
under the intake manifold. Not hard to replace at all.
-
11-03-2007, 09:21 AM #3
When taking off the intake maniold what else do I have to take off before the intake manifold itself?
-
11-03-2007, 09:25 AM #4
check out the write up at ls1howto.com for the ls1 to ls6 intake swap. It gives detailed instructions on removing the intake. One thing to watch for is the oil pressure sender on the drivers side rear of the block. Very easy to break that off with the brake booster vacuum hose when pulling the intake out. It's cheap to replace but better if not broken at all.
-
11-03-2007, 09:33 AM #5
- Join Date
- Jul 2005
- Location
- Jacksonville, FL
- Posts
- 2,723
There are two knock sensors under the intake, you're throwing the code for the front one. If you're going to remove the intake I'd replace both sensors while it's off.
-
11-03-2007, 09:34 AM #6
-
11-03-2007, 09:44 AM #7
Thanks for all the help guys! I'll check out the how to's and do it myself for the experience. I'll keep you posted on progress.
-
11-03-2007, 11:25 AM #8
If you can turn a wrench at all you can swap out those sensors. 2 other things I can think of are don't overtighten the manifold bolts when you put it back on, the torque readings are in in/lbs and not ft/lbs. I think it works out to be ~10 ft lbs or so. The other thing is the socket size for the sensor. It's big. I forget what size but I think it was like a 20mm or something like that. I'll look it up this afternoon and post up the size.
-
11-03-2007, 11:46 AM #9
Thanks, I'd appreciate it.
-
11-03-2007, 07:32 PM #10
- Join Date
- Mar 2007
- Location
- St Louis, MO
- Posts
- 155
Pewter- 99 Firehawk convertable
I had to replace mine, the seals around them was soaked in oil, don't know how they got like that,but it caused the front to go bad. I to replaced both of them. Haven't had any problems since then.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
knock sensor code with new knock sensors?
By zaaronz in forum General HelpReplies: 13Last Post: 02-27-2011, 06:26 AM -
Knock Sensor ?
By Jheath5193 in forum General HelpReplies: 1Last Post: 01-20-2011, 02:31 PM -
Which knock sensor do I need?
By SMWS6TA in forum General HelpReplies: 7Last Post: 12-27-2010, 10:09 PM -
will bad knock sensor knock down hp
By zaaronz in forum General HelpReplies: 11Last Post: 10-14-2010, 04:49 PM -
Knock Sensor/Oil Pressure Sensor Issue
By Slow '99 in forum External EngineReplies: 1Last Post: 04-04-2007, 08:28 AM
Bookmarks