installing clear corners

**01redm5** · 12-05-2005, 06:29 PM

alright guys i know this is a completley newb question but i figure i will ask it before i tackle this in the morning. i just got in my clear corners, and breifly looked at my car to see how they are installed. i saw no way to remove the old ones. now granted it was dark when i just looked, but i seen no way to remove them from the front, or under the car. any help before i do this in the morning would be great, thanks in advance, and pleas dont flame me to hard, im use to the w-bodies and the f-bodies yet.

**~redlinels1~** · 12-05-2005, 07:00 PM

Two options

1.) Install from the access panels underneath the car. Its usually harder this way but you dont remove anything

2.) Remove the headlight (its held in by 1 10mm bolt) and install from the top. Its much easier this way. When you're putting the headlight back in make sure to tape the plastic around the headlight. You will probably scratch it.

**01redm5** · 12-05-2005, 07:20 PM

thanks a lot.............also what holds the corner is, just a bolt or what?

**~redlinels1~** · 12-05-2005, 07:25 PM

three 7mm ( I think ) screws hold the corner lense in place, twist out the bulb sockets and remove the three screws and lift the amber lense out. Sometimes you will have wiggle it out but it will come out. When re-installing the bulb sockets make sure the foam gasket is still on the bulb socket.

Btw...I mentioned to use a tape to protect the paint when putting the headlight unit back in. It would be a good idea to put the tape on it when pulling the headlight out too.