help fast

**jamesgill7360** · 09-23-2010, 09:28 AM

ok i just replaced my clutch master cylinder it was a bitch but i got it..
i have the drill mod for bleeding.. right now im trying to bleed it but it just wont gain presser no matter how many time i push it down...
and help guys? i need this done befour 2. please and thanks

**sunsetorangess** · 09-23-2010, 11:24 AM

I know its a bit late but how are you trying to bleed the master?
J

**jamesgill7360** · 09-23-2010, 01:32 PM

It's ok. And I was pumping it for a while then hold it down and open the bleed valve then close it. And repeat

***SMWS6TA*** · 09-23-2010, 01:46 PM

I had the same problem too then I did the drill mod. I notice that if you bench bleed the master then cap the end till you get it back on the slave it will bleed in less time. other wise it took me 2 hours to bleed. I'll be getting a vacuum bleeder next time.

**jamesgill7360** · 09-23-2010, 03:35 PM

Thanks man I been at it for allmost an hour and seams allmost done. Thanks so much for the info. I thought I broke it I was about to take it to a shop you saved me tun of money!!! Thanks agen