Turned out to be quite the engineering challenge. Circuitry worked flawlessly but then the case we chose turned out to be a bit too small to route the power and test wires out without putting any stress on the PC Board.

Then there were the faceplate labeling problems. The company we chose took about three times to get the artwork corret then when we received the first proofs they were printed on what we considered substandard material with text that would rub off if you got gasoline on it. Found a local firm that worked hand in hand with us and produced a quality product. Just received them yesterday so today we've been putting the finished circuit boards in the cases and doing all the final assembly.

We're darn proud of these, truly a professional piece of test equipment that can be used on any fuel injected car as we're including not only the standard Bosch plug but a universal adapter as well.

More info on our website, click on the tester link to the left:
http://www.iecoklahoma.com