Results 1 to 4 of 4
Thread: EGR Plug
-
07-15-2008, 09:41 PM #1
EGR Plug
Can i cut it then wrap the wires in elec tape... then just wire loom it to look normal?
-
07-15-2008, 09:57 PM #2
It would be a lot safer and cleaner looking to just leave it and tie wrap it out of the way. Cutting wires then leaving bare, can lead to many problems when they corrode> If you are bent on cutting it off heat wrap the wires with a bit of dielectric grease, do them individually then as a pair. that should make them near water proof and look way cleaner then e-tape.
-
07-16-2008, 07:43 AM #3
alright i will see what i can do w/o it
-
07-16-2008, 10:54 AM #4
- Join Date
- Jul 2005
- Location
- Jacksonville, FL
- Posts
- 2,723
If you're talking about the connector after doing !EGR after you cut it and wrap the wire ends just tuck them back into the harness tube.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Best Plug wires and plug gap
By Intrepidman in forum General HelpReplies: 12Last Post: 12-30-2008, 09:30 AM -
plug gap
By twozs in forum General HelpReplies: 6Last Post: 04-17-2008, 03:49 AM -
TR6 plug gap
By Mr. Luos in forum Internal EngineReplies: 3Last Post: 10-30-2006, 10:38 AM -
What is this plug for?
By RoadKillBunny in forum General HelpReplies: 0Last Post: 04-01-2006, 04:11 PM -
Spark plug wire and plug!
By RYDER661 in forum General HelpReplies: 2Last Post: 03-13-2006, 09:01 PM
Bookmarks