Results 1 to 5 of 5
-
04-28-2010, 06:30 PM #1
- Join Date
- Oct 2008
- Location
- Coral Springs, Fl
- Posts
- 5,774
Sunset Orange Metalic- 2001 Camaro SS
Need info on modular wheel disassembly
Ok so i have a set of IForged Senekas and there are some imperfections with the chrome, one wheel in particular. They are 3 piece wheels and i've done some research but wanted to see what others thought on the subject.
Have plans to have them done with a black chrome finish, if not that then i'll just have them re-chromed.
I know the tires will have to be dismounted and i will need new fastening hardware, I also read on another site that the bolts should be torqued to 27 ft/lbs, not sure how accurate this is. From what i have read the centers are pressed into the barrel but i don't know for sure.
No rush on this project but I want to get as much info as i can on this.
Thanks in advance
Here is a pic of one of the wheels
Last edited by tatertot91; 05-23-2010 at 02:40 PM.
-
04-30-2010, 04:34 PM #2
- Join Date
- Oct 2008
- Location
- Coral Springs, Fl
- Posts
- 5,774
Sunset Orange Metalic- 2001 Camaro SS
anybody?
-
05-03-2010, 05:34 PM #3
- Join Date
- Oct 2008
- Location
- Coral Springs, Fl
- Posts
- 5,774
Sunset Orange Metalic- 2001 Camaro SS
guess i'm all alone on this
-
05-15-2010, 06:37 AM #4
- Join Date
- May 2010
- Location
- San Diego, California
- Posts
- 18
Black- 2000 Pontiac Trans AM WS6
I know this is not much help and may not apply to your brand but my HRE 3 piece rims had what looked to me like a silicone sealant applied to the inside center or a little off center not the face of the rim with tire removed i know this because when i had my tires replaced the tire tech punctured the seal and i had to send it back to HRE for repair i also know they replaced not re-used all the fastening hardware my HRE 545s look similar to yours
-
05-15-2010, 08:55 PM #5
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
A Little Help with Disassembly and Painting
By smitty504 in forum Appearance SectionReplies: 4Last Post: 10-06-2012, 05:12 AM -
Question: McLeod SFI Approved Modular Bellhousing, Help
By SMWS6TA in forum General HelpReplies: 18Last Post: 07-12-2010, 06:52 AM -
Need info on wheel studs
By 808chevyz28 in forum Wheels and TiresReplies: 2Last Post: 07-19-2009, 10:03 AM -
McLeod modular Bellhousing probs
By AKz06 in forum Manual TransmissionReplies: 2Last Post: 02-11-2009, 09:27 PM -
Install of Loudmouth Modular Instructions anyone?
By SSwt00SS in forum General HelpReplies: 0Last Post: 03-16-2006, 02:22 PM
Bookmarks