Lowered with a 28" tire?

[One_Bad_TA]

I'm planning on lowering my ws6 with Strano springs and I drive it on the street with the stock rims and tires. But at the track I use a 28" tall slick and on stock springs they fit but are very close to rubbing. I am not sure if I should lower the car or if I would not be able to use my slicks, so does anyone have their car lowered and run a tire that is roughly the same size with any problems? Or what was needed to be done to make it work?

[Mr. Luos]

I am sure mine would have fit 28" tires if I had wanted too.
Just never got around to it.

Strano springs.

[One_Bad_TA]

I am sure mine would have fit 28" tires if I had wanted too.
Just never got around to it.

Strano springs.

Thats what Im hoping, my front springs are saggin but the rear still sits pretty high so I want to make it look a little better but if it hinders me from racing then I can't do it lol. I do have an airbag in the passenger coil spring but I wasn't sure if it would lift it enough to make these fit even if I got another air bag. Thanks Luos

[xmarkx]

I have 335/30-19 in the back which is a hair under 27" and I have sportline springs which are almost a 2" drop. I only rub on the outer fender edge because my wheels are so wide but I still have room in the wheel well. I'd think a 28" tire would be fine. it depends also on the width of the tire and the offset of the wheel as well on where it's going to rub.

[One_Bad_TA]

The tire is about 10" wide so it isnt huge. I also have v6 camaro 16's on it so I dont know what the offset is. I have adj lca's and phb so I can center the tire better in the wheel well too.