Vette lettering removal on FRC HELP!

[01SOMSS!]

how hard is it to remove the corvette lettering in the FRC's? is there a write up? thanks!

[Y2KPewterSS]

Do you have the black ones with the red lettering? If so, you would need to fill them in and smooth them.

[01SOMSS!]

no its the red ones black lettering. I want to replace the lettering with a camaro decal from brent franker.I also want to paint them black
http://s246.photobucket.com/albums/g...rrent=frcs.jpg

[Y2KPewterSS]

I had the colors backwards but still the same process. Also, those will have to be cut to fit an fbody.

[jujofields]

^^^^agreed...you have to fill them in & then smooth it out-after that you can paint them & apply your decals. Also, the corvette FRCs have to be cut to fit because the engine in the vette is out further in the bay, whereas the engine in the f-body is further back in the compartment; also they have to be cut b/c of a few different part placements between the vette & the f-body. A little side note: I'd recommend covering the bottom of the FRCs with heat shielding tape when you put them on, so they don't warp or melt...

[01SOMSS!]

cut? how hard is that? is there a write up?I'm going to pick them up for 50 bucks, but it sounds like its going to be a bitch to do all this.

[Y2KPewterSS]

cut? how hard is that? is there a write up?I'm going to pick them up for 50 bucks, but it sounds like its going to be a bitch to do all this.

They need to be cut like mine above to fit.