Triple Gauge Pillar on 2000 WS6

[fbodyNATION]

i want to install a triple gauge pillar on my 00 WS6 is it hard to install,i meant is it hard to hook electric part of it up?

[pajeff02]

I have a 2 pod piece with a fuel pressure and air-fuel gauge. It was not difficult at all to install and the wire runs into the pillar were very easy. I did run the wires through the driver side firewall in lieu of behind the PCM as this created a much shorter run. There is a thread on doing this if you want to look at it. What gauges are you installing?

[fbodyNATION]

[QUOTE=pajeff02;2681243]I have a 2 pod piece with a fuel pressure and air-fuel gauge. It was not difficult at all to install and the wire runs into the pillar were very easy. I did run the wires through the driver side firewall in lieu of behind the PCM as this created a much shorter run. There is a thread on doing this if you want to look at it. What gauges are you installing?[/QUOTE thanks PAJeff,i plan on installing the trans gauge,air-fuel gauge and fuel pressure,i want them to light up red like the gauge cluster any suggestions?

[MudStainKILLA]

Ill send you a PM wih a link to a company that sells both red light gauges and the pod man

[MudStainKILLA]

pm sent

[jetaws6]

I have a 2 pod piece with a fuel pressure and air-fuel gauge. It was not difficult at all to install and the wire runs into the pillar were very easy. I did run the wires through the driver side firewall in lieu of behind the PCM as this created a much shorter run. There is a thread on doing this if you want to look at it. What gauges are you installing?

Wheres the link to the thread you are talking about pajeff02

EDIT: Found it. Where inside the car do those holes end up?

http://www.ls1.com/forums/showthread...h-the-firewall

[fbodyNATION]

pm sent

thanks i got it

[pajeff02]

The holes come out on the left side of the footwell, just below a box of some sort that is tucked up under the dash. Don't allow the drill bit to go very far when it breaks through the firewall.

I also went with red -- my air-fuel gauge is the digital Innovate and my fuel pressure is a digital AutoMeter.

[98maro]

Ill send you a PM wih a link to a company that sells both red light gauges and the pod man

Could you send me the link ?
Thanks

[jetaws6]

Nice where did you get the grommet from or is it just a paste?

[pajeff02]

Just a standard rubber grommet -- you can get them at hardware stores, Lowe's, and possibly Radio Shack.