Results 1 to 8 of 8
-
10-07-2009, 11:24 AM #1
- Join Date
- Mar 2006
- Location
- ND
- Age
- 41
- Posts
- 11
- iTrader
- 0
Black- 99 C5
FS or trade. 95 Mustang w LS1 swap
Located in Williston, ND. Email: iownedu@hotmail.com
I am abandoning this project, easy finish for someone.
It needs to be measures for a driveshaft and then order. An aluminum one is about $500 max.
The ECU and wiring harness need to be put in, simple plug and play with the power wires etc all labeled. I sent off the wiring harness to be modified for this application to the tune of $800.
Then the power wires for all the guages are all setup, all you will have to hook up is the wires that go to the sensors.
The rear pipe of the driver side header needs to be modified to clear the steering shaft, then obviously install the steering shaft.
I think that is really about it other than small odds and ends like radiator plumbing and a tranny cooler. Exhaust also needs to be put on, have headers, mufflers and xpipe.
Here are the mods.
AJE Tubular cross member, motor mounts, tubular a-arms, coilover setup, upper camber plates. $1300
LS1 and a 4l60e auto trans $4000
LS6 Intake/Cam $500
Autometer guages $900
Kooks Headers $750
Walbro 255 intank $110
2 Flowmaster 40 series mufflers and an xpipe $350
Steering rack offset bushings $50
Flaming river manual steering rack $310
Flaming River slim steering shaft (to clear headers) $420
Aftermarket throttle body (cant remember brand) $300
Probably forgetting alot of things
Anyway with the purchase of the car I have almost $11k into it as it sits.
Ill take $7200, cars with this setup are known to break 11's rock stock motor.
This was before the Flaming river rack was installed.
-
10-07-2009, 01:25 PM #2
That's a sleeper, nice work.
-
10-08-2009, 11:23 AM #3
- Join Date
- Feb 2008
- Location
- NEW JERSEY
- Posts
- 814
- iTrader
- 0
PEWTER- 2001 TRANS AM WS6
look at that thar be a fast butt stang
-
10-09-2009, 08:00 PM #4
i like the idea.. but imo the ls1 z28/TA's run in the 11's stock and carry things like ac, power steering exc... and can be had for about $7500
i'm not bashing this project at all. just saying. but good luck with the sale. free bump for a good sleeper.
-
10-09-2009, 08:09 PM #5
-
10-09-2009, 08:23 PM #6
i might be wrong.. i should have looked again before i said anything. my fault. i was almost sure they ran high 11's... it's been a long day. like i said i like the idea.
-
10-09-2009, 08:28 PM #7
yea just looked it up best of high 12's mid/low 13's. but thats from the factory bone stock..
anyway..
-
10-09-2009, 10:58 PM #8
- Join Date
- Mar 2006
- Location
- ND
- Age
- 41
- Posts
- 11
- iTrader
- 0
Black- 99 C5
Foxbody/SN95 mustangs are quite a bit lighter than 98-02 F-body's.
Still for sale.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
For Sale: for sale or trade mustang
By SSMOKEshow in forum Parts For Sale / TradeReplies: 2Last Post: 12-17-2008, 08:25 PM -
Trade 86gt Mustang 9.1et For Ls1
By outlaw418 in forum Vehicles For Sale / TradeReplies: 0Last Post: 08-02-2008, 07:26 PM -
should i trade my mustang for a TA?
By drewhenderson13 in forum Firebird / WS6Replies: 50Last Post: 03-31-2008, 04:04 PM -
mustang FS/Trade
By onefastfox88 in forum Vehicles For Sale / TradeReplies: 6Last Post: 10-16-2005, 02:36 PM -
Want to Trade Supercharged 475 HP Mustang for 96 - 00 WS6 0r SS
By Spower in forum Vehicles For Sale / TradeReplies: 1Last Post: 08-17-2005, 11:02 AM
Bookmarks