Results 1 to 7 of 7
Thread: Cobalt Tach Install, Help!
-
11-02-2005, 01:08 PM #1mgradleGuest
Cobalt Tach Install, Help!
Hi, I recently purchased a Autometer Cobalt tach for my 95 z28. I was trying to figure out the best 12 volt ignition supply to use for the red wire and where I should go with the green wire ignition? Any help is appreciated.
-
11-02-2005, 01:09 PM #2
hold on i know this one
-
11-02-2005, 03:29 PM #3mgradleGuest
Also, looking at the illumination diagram would I have to splice into the grey or black wire to make the tach light up when the headlight are on?
-
11-02-2005, 04:43 PM #4
ok how many wires are on it??
red=power
white=light
black-ground
green=ignition >>i think??
-
11-03-2005, 02:39 AM #5mgradleGuest
Right! The green is suppose to go to the coil and splice into the white wire, but I can't find the coil. It is suppose to be on the drivers side by the head. I think it is under my cold air intake?
-
11-03-2005, 04:54 AM #6
i dont really know much about the ignition on the LT1 cars all i know is that opti is a bitch and a half man, sorry
-
07-26-2009, 10:35 PM #7
the opti isnt that bad, just in the wrong spot.... but yea the coil is right under the intake
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Autometer monster tach install
By Asian LSX in forum Computer & TuningReplies: 1Last Post: 10-30-2011, 12:55 PM -
no tach
By CHRISFORMULA in forum General HelpReplies: 6Last Post: 08-25-2010, 09:05 AM -
LS1 vs C3 tach
By Zmanx in forum Stereo and ElectronicsReplies: 1Last Post: 12-06-2008, 09:38 AM -
Autometer Tach Install
By fordkiller in forum General HelpReplies: 1Last Post: 06-01-2006, 02:07 PM
Members who have read this thread: 0
There are no members to list at the moment.
Bookmarks