Results 1 to 4 of 4
Thread: just got my cam in!!!!!!!!!
-
03-11-2007, 04:52 PM #1in doubt tach it out!!
- Join Date
- Feb 2007
- Location
- Ft.pierce,fl
- Posts
- 135
BADASSZ28
just got my cam in!!!!!!!!!
i just installed my cam and fired it up and of course it wont idle at all , got rid of the egr,air and rear o2 sensors plus all i had was open headers cause i am waiting for my converter (fuddle 3400) so i didnt put on the y-pipe but man that trick flow cam sure sounds good with open headers i didnt run it that long cause of the open headers but just let yall know i am fixin to be haulin some serious ass!!!!!!!!!!!!!
-
03-16-2007, 08:05 PM #2in doubt tach it out!!
- Join Date
- Feb 2007
- Location
- Ft.pierce,fl
- Posts
- 135
BADASSZ28
hey no replys yall need to tell me something how long did it take you guys to install cam , springs, pushrods and lt it took me like 15 hours or something i am curios so please reply!!!!!!!!!
-
03-16-2007, 08:52 PM #3Senior Member
- Join Date
- Feb 2007
- Location
- St Thomas, PA
- Posts
- 5,046
White- 1998 Trans Am
Did you do the timing chain too ? I think that was the booger of all boogers...
-
03-17-2007, 02:19 PM #4in doubt tach it out!!
- Join Date
- Feb 2007
- Location
- Ft.pierce,fl
- Posts
- 135
BADASSZ28
no i didnt but i should have and i will soon but it was pretty tight , but i have done onw before and it sucks especially the oil pump!!
Reply With QuoteThread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks