Seatbelt "holder" attached to headrest

**theGeneral** · 03-26-2008, 07:03 AM

Meh, tried to explain it the best I could in the title. I need the not so square thing that the seatbelt goes through that is attached to the headrest. Had a fat friend get in the car, leaned on it and snapped it.

How would I go about installing that, anyway? Ouch. I think I would have to remove the whole seatbelt assy.

**1fastcamarosss11** · 03-26-2008, 07:17 AM

on the camaro i have they was a small piece cut on the ones i had so i bought a whole new one and just cut a little slit in it. looks just like the other one.

on the ta you will need to take the belt out.

**GULLETT17** · 03-26-2008, 07:36 AM

on a ta you wont have to remove the whole assembly . . . just detatch the belt from the floor, remove seat belt guide from seat, and slide it down the belt. pretty easy 15min job

**kev70ss** · 03-26-2008, 10:58 PM

My dumb ass friend broke my passenger side. I went to the dealer and i was surprised it only cost about $12. Also i believe the bracket with the slit is for the convertible.

**1fastcamarosss11** · 03-26-2008, 11:11 PM

Originally Posted by kev70ss

My dumb ass friend broke my passenger side. I went to the dealer and i was surprised it only cost about $12. Also i believe the bracket with the slit is for the convertible.

maybe?? mine is.

**red99ws6** · 04-07-2008, 04:17 PM

i got mine from hawkthirdgenparts and they had them with or without the slit. i order without just because that was the way mine was. like gullet17 said it is a one bolt deal take just a few minutes. just kinda tricky getting the seatbelt buckle through the guide. it is a tight fit