FS: Edelbrock super victor and fuel rails $415 shi

[haighter]

I have a edelbrock super victor and fuel rails for sale that I got from summit racing. New after shipping was about $530. Also that didnt include the gaskets. I have it listed for SOLD shipped. Here's a link to summits sight. http://www.summitracing.com/parts/EDL-28095/
the steel breaded fuel lines and fittings are not being sold with the intake. If you would linke them please make me an offer. If you want to pick this up fast my phone number is XXXXXXXXXX my pay pal address and email is XXXXXXhaight@yahoo.com. First come first serve.

[Duffster]

So you sold this in about an hour? Cool for you, but you still suck for not selling it to me

[haighter]

It was actually sold in about 37 min from 1 forum i posted it on. I do have a LOT of stuff if anyone is interested. What were you looking for besides the Super Victor?

[Duffster]

I've got the elbow and tuning ability and injectors...just the intake right now...no rush though

[MrMasterCraft]

What other stuff ya got??

[haighter]

What other stuff ya got??

A brand new d1sc and f2 Procharger w brackets and red race bypass valves, 403 w/ 1/2" arp head studs pinned billet mains, intous pistons Wiseco and JE, brand new mezier waterpump, brand new nano system w/15# bottles, moser 12 bolt with 4.10's true track 33 spline alxes and custome 3.5" aluminum ds, Wiseco boost pistons, nitrouse stand alone fuel cells, 3 t-56 trans viper spec m6 and also a fully built m10 with 32 spline main shaft, 42 60 96lb injectors, aem controlers and harness, LF two step, ft nitrous controler, msd windo switch, cooling mist meth kit, race tronics walbro 255 intank pump kit and some rims and tires.

My cell is 209-559-7342.

[Spikito]

so that super vic will work on and LS1?

would you need a cowl hood for that?

[Duffster]

Either cowl or cutting hole in hood. . . . and probably also reworking the windshield cowl area (unless you've got a low-profile elbow).

[haighter]

so that super vic will work on and LS1?

would you need a cowl hood for that?

Yes it will work on the LS1. I wouldnt rec doing it on a stock motor at all. It is only for performance builds.

Either cowl or cutting hole in hood. . . . and probably also reworking the windshield cowl area (unless you've got a low-profile elbow).

I had to remove my wipers completely to use the super Victor. I would not rec. using a low profile elbow. You will really hurt how the air flows and making you lose potential power.

how much you want shipped to 44107 cleveland ohio.

please give me a call at 209-559-7342 if you really are interested in the rear end. Your pm box is full. Thanks, C. J.

[Duffster]

The round elbow yes, with the square elbow, no.





and my favorite...



Mine is powder coated black