Results 1 to 14 of 14
Like Tree4Likes
  • 1 Post By mrr23
  • 1 Post By mrr23
  • 1 Post By mrr23
  • 1 Post By Y2KArcticSS

stillen splitter

This is a discussion on stillen splitter within the Appearance - 5th Gen forums, part of the 5th Generation Chevrolet Camaro 2010 - 2015 category; arrive today....

  1. 03-20-2018, 05:17 PM #1
    mrr23
    mrr23 is offline
    Senior Member mrr23's Avatar
    Join Date
    Jul 2005
    Location
    orlando, fl
    Posts
    7,364

    black
    2014 camaro 2ss/rs

    Send a message via AIM to mrr23

    stillen splitter

    arrive today.









    Reply With Quote Reply With Quote
  2. 03-21-2018, 03:15 AM #2
    pajeff02
    pajeff02 is offline
    Veteran pajeff02's Avatar
    Join Date
    Feb 2009
    Location
    Mansfield, PA
    Posts
    22,146

    Black & Blue
    '02 WS.6 / '07 Suburban

    What's on the front of the car now? Is that an aftermarket air dam in your profile pic?
    Reply With Quote Reply With Quote
  3. 03-21-2018, 08:02 AM #3
    mrr23
    mrr23 is offline
    Senior Member mrr23's Avatar
    Join Date
    Jul 2005
    Location
    orlando, fl
    Posts
    7,364

    black
    2014 camaro 2ss/rs

    Send a message via AIM to mrr23
    Stock air dam under car. What you see us the actual bumper.
    Reply With Quote Reply With Quote
  4. 04-04-2018, 06:44 PM #4
    mrr23
    mrr23 is offline
    Senior Member mrr23's Avatar
    Join Date
    Jul 2005
    Location
    orlando, fl
    Posts
    7,364

    black
    2014 camaro 2ss/rs

    Send a message via AIM to mrr23
    splitter is now on. instructions said to remove bumper cover. i say nay nay. instead of taking it off to put screws in, i just taped it on, drilled holes and bolted it on.

    removed the two 10mm bolts and six 7mm bolts so i could pull down on the cover





    taped on







    drilled holes and put bolts in









    and done

    Reply With Quote Reply With Quote
  5. 07-29-2018, 03:54 AM #5
    mrr23
    mrr23 is offline
    Senior Member mrr23's Avatar
    Join Date
    Jul 2005
    Location
    orlando, fl
    Posts
    7,364

    black
    2014 camaro 2ss/rs

    Send a message via AIM to mrr23
    splitter has disappeared. noticed it gone yesterday. can't figure out how it happened.
    Cold Air Intake, Muffler Delete, Vinci High Performance Dual Valve Springs, Hardened Pushrods, Yella Terra 1.85 Rockers, Some Hydropdipped Stuff, Strut Tower Brace, Some SS Badges, boost/vacuum gauge, fuel pressure gauge, some checkered stripes, drilled/slotted rotors, ZL1addons Stealth wickerbill, Ruxifey LED side markers
    Reply With Quote Reply With Quote
  6. 07-30-2018, 05:28 AM #6
    Y2KArcticSS
    Y2KArcticSS is offline
    Moderator
    Y2KArcticSS's Avatar
    Join Date
    Mar 2007
    Location
    Henryetta/Tulsa Oklahoma
    Age
    38
    Posts
    3,675

    2016 Camaro SS - Summit
    2001 Trans Am WS6 - NBM

    Did the screws go with it, or did it rip away? Hindsight, it probably would have been a good idea to put in larger diameter washers to make sure the plastic doesn't rip away from the screw under wind load.

    2016 Summit White 1SS - The DD - Mishimoto catch can, Solo axleback & secondary cat delete, LED sidemarkers & reverse lights, head/taillight blackout, RCC custom badges
    2001 NBM Trans Am WS6 - Torquer V2 cam, Yank 3000 stall, Transgo kit, Racetronix fuel pump, TSP LTs, Magnaflow catback, Strano Springs/Koni STR.T shocks, 17x9.5/17x11 TTII's
    2000 Arctic White SS #1667 - Sold
    Reply With Quote Reply With Quote
  7. 07-30-2018, 05:49 AM #7
    mrr23
    mrr23 is offline
    Senior Member mrr23's Avatar
    Join Date
    Jul 2005
    Location
    orlando, fl
    Posts
    7,364

    black
    2014 camaro 2ss/rs

    Send a message via AIM to mrr23
    Screws still there. One piece is still holding in with a screw. Im still baffled on how i didnt hear or notice when it happened.
    Reply With Quote Reply With Quote
  8. 07-30-2018, 07:59 AM #8
    Y2KArcticSS
    Y2KArcticSS is offline
    Moderator
    Y2KArcticSS's Avatar
    Join Date
    Mar 2007
    Location
    Henryetta/Tulsa Oklahoma
    Age
    38
    Posts
    3,675

    2016 Camaro SS - Summit
    2001 Trans Am WS6 - NBM

    It may have pulled off one side and flew off beside the car. You would most likely have heard it if you ran it over.

    If you get another I'd for sure recommend large washers to give more surface area holding it up, at least on the bottom side but I'd err on the conservative side and make a washer sandwich.
    Reply With Quote Reply With Quote
  9. 07-31-2018, 05:59 AM #9
    mrr23
    mrr23 is offline
    Senior Member mrr23's Avatar
    Join Date
    Jul 2005
    Location
    orlando, fl
    Posts
    7,364

    black
    2014 camaro 2ss/rs

    Send a message via AIM to mrr23
    Not going to bother getting another one.
    Reply With Quote Reply With Quote
  10. 07-31-2018, 06:36 AM #10
    Y2KArcticSS
    Y2KArcticSS is offline
    Moderator
    Y2KArcticSS's Avatar
    Join Date
    Mar 2007
    Location
    Henryetta/Tulsa Oklahoma
    Age
    38
    Posts
    3,675

    2016 Camaro SS - Summit
    2001 Trans Am WS6 - NBM

    I don't blame you.
    mrr23 likes this.
    Reply With Quote Reply With Quote
  11. 06-23-2019, 01:42 PM #11
    olemiss99
    olemiss99 is offline
    Junior Member
    Join Date
    Jun 2019
    Location
    US
    Age
    53
    Posts
    15
    That made it look mean!

    Sent from my SM-G930V using Tapatalk
    Reply With Quote Reply With Quote
  12. 03-06-2023, 09:50 PM #12
    Jared09
    Jared09 is offline
    Junior Member
    Join Date
    Mar 2023
    Location
    Canada
    Posts
    2
    Hi there, You've done an incredible job. I will definitely dig it and personally recommend to my friends. I am confident they'll be benefited from this thread.
    Reply With Quote Reply With Quote
  13. 03-13-2023, 08:11 PM #13
    EthanWalker
    EthanWalker is offline
    Junior Member
    Join Date
    Oct 2022
    Location
    Walker
    Posts
    9

    White
    That's exciting to hear. www.bestcasepropertygroup.com/
    Reply With Quote Reply With Quote
  14. 03-23-2023, 01:33 PM #14
    KellyP
    KellyP is offline
    Junior Member
    Join Date
    Dec 2022
    Location
    Baltimore
    Posts
    3
    What a bummer! I've seen reviews and comments saying that the front splitter has fallen off at high speeds or come loose over long or short periods of time after install.

    Internet Marketing Services
    Last edited by KellyP; 03-23-2023 at 01:35 PM.
    Reply With Quote Reply With Quote
« RUXIFEY Smoked Lens LED Side Marker Lights | Stealth wicker bill »

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. 6le diffuser and splitter
    By red00bird in forum Appearance Section
    Replies: 25
    Last Post: 06-23-2012, 09:33 AM
  2. Splitter
    By davidz28 in forum Appearance Section
    Replies: 12
    Last Post: 12-01-2010, 09:05 PM
  3. rear splitter
    By Darkrider02 in forum Camaro / SS
    Replies: 10
    Last Post: 11-20-2010, 05:57 PM
  4. Splitter
    By Sarge in forum GTO
    Replies: 41
    Last Post: 02-19-2009, 07:48 PM
  5. New Splitter...
    By BaaaadGTO in forum GTO
    Replies: 17
    Last Post: 12-09-2008, 11:53 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules