Nitrous 1st timer...

**MagicMan** · 09-04-2006, 06:50 PM

First, should I be ok spraying my 111k mile LS1?

If yes, what, besides the standard juice kit, (I'm going to go w/an NX wet kit spraying a 75 shot) should I buy? I will be getting the purge kit & remote bottle opener. Do I NEED a bottle heater etc?

Are TR55 plugs gapped at 0.050 suitable for juice?

Also, I want to mount the bottle (10 lb) in the spare tire well. What am I going to need to fab up to get it in there safely & will the remote opener fit?

Anything else I need to know or buy?

**Sarge** · 09-05-2006, 03:57 AM

75 shot aint gonna kill your motor any faster than not spraying..
Yes gap the TR55's at .050-.045....
Bottle heaters are not for the comfort of the bottle...they are to get the pressure up into the safe zone of 950lbs minimum...spray at a lower pressure and you can have intermittant nitrous flow...bad thing....WOT switch/Window switch...nitrous filter.....good tune....have fun.

**mrr23** · 09-05-2006, 04:29 AM

check with www.harrisspeedworks.com i think they have a spare tire well bottle mount.

**MagicMan** · 09-05-2006, 04:25 PM

Originally Posted by mrr23

check with www.harrisspeedworks.com i think they have a spare tire well bottle mount.

Didn't see one

**Nasty TA** · 09-06-2006, 03:10 PM

Do not use tr55 ngk because they are for normally asperated cars not nitrous cars. Use TR6 ngk and gap to 35. If you gap them to .45-.50 you run the risk of a flame out. Trust me on this i do this for a living and have a 200 shot on my TA . A bottle heater i a good purchase because it helps to get the bottle up to temp easier and faster. It alows you to get a full shot every time. Good luck and hold on.