4L60E Output Shaft Seal Leak

rbob93 · 01-06-2006, 11:33 AM

What am I getting into if I replace it myself?
Any Special tools required?

Thanx, Bob

***mrr23*** · 01-06-2006, 06:56 PM

it's an easy replacement. hammer, screwdriver, and 11mm (7/16") wrench is about all you'll need. support vehicle safely to get under car. remove the driveshaft with the 11mm wrench from the rear. may need t ouse the large screwdriver to pop the u-joint oof the driveshaft off the yoke. slide out of trans. use screwdriver to pry out the old seal. use hammer to tap in the new seal. slide driveshaft back in. reinstall on rear. done.

rbob93 · 01-06-2006, 09:50 PM

Quote:

Originally Posted by mrr23

it's an easy replacement. hammer, screwdriver, and 11mm (7/16") wrench is about all you'll need. support vehicle safely to get under car. remove the driveshaft with the 11mm wrench from the rear. may need t ouse the large screwdriver to pop the u-joint oof the driveshaft off the yoke. slide out of trans. use screwdriver to pry out the old seal. use hammer to tap in the new seal. slide driveshaft back in. reinstall on rear. done.

So nothing special, most like any output shaft seal that I've done over the years.

Thanx for the help.

***mrr23*** · 01-07-2006, 04:30 PM

no problem.

01-06-2006, 11:33 AM	#1
rbob93 Member Since 2000 Veteran Member Join Date: Aug 2005 Location: World Famous Daytona Beach Posts: 2,617 2000 CamaroSS Sebring Silver	4L60E Output Shaft Seal Leak What am I getting into if I replace it myself? Any Special tools required? Thanx, Bob

01-06-2006, 06:56 PM	#2
*mrr23* The Multiple Moderator Join Date: Jul 2005 Location: orlando, fl Age: 41 Posts: 7,023 1999 & 2000 formula white & black	it's an easy replacement. hammer, screwdriver, and 11mm (7/16") wrench is about all you'll need. support vehicle safely to get under car. remove the driveshaft with the 11mm wrench from the rear. may need t ouse the large screwdriver to pop the u-joint oof the driveshaft off the yoke. slide out of trans. use screwdriver to pry out the old seal. use hammer to tap in the new seal. slide driveshaft back in. reinstall on rear. done. __________________

01-07-2006, 04:30 PM	#4
*mrr23* The Multiple Moderator Join Date: Jul 2005 Location: orlando, fl Age: 41 Posts: 7,023 1999 & 2000 formula white & black	no problem.