Results 1 to 2 of 2
Thread: Ls 3
-
11-17-2016, 08:59 AM #1
- Join Date
- Nov 2016
- Location
- THOMASVILLE,NC
- Posts
- 1
Ls 3
I am swapping motors in my 1955 Chevrolet to a ls 3 to a 700 R4 transmission the ls3 flex plate does not align to the torque convertor ? Chevrolet said there are two different flex plates I have both they do not align. the originally flex plate appears to have had the holes elongated rough measurements bolt holes 9 1/4 center to center and drive gear on flex plate original is 12 7/8 outer edge of the teeth
Last edited by Timothy Crews; 11-17-2016 at 10:12 AM. Reason: adding a note about elongating the flex pale holes
-
11-17-2016, 12:25 PM #2
- Join Date
- Oct 2016
- Location
- Peckville
- Posts
- 4
Sent from my iPhone using Tapatalk
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks