Results 5,321 to 5,340 of 7102
-
11-17-2016, 10:39 AM #5321
- Join Date
- Feb 2016
- Location
- Georgia
- Posts
- 1
Pewter- 1999 Trans Am
Walked outside and looked at it while daydreamin how to improve the small maintenance issues. At times I'm having an idle issue that comes and goes. At times upon cranking it rises to around 2500 rpm before dropping to allow me to go in gear.
-
11-17-2016, 11:44 AM #5322
Gents, as you have tajen apart the dashes, on my '99 ws6 stick, where does a/c & heat vent into floor area EXACTLY? Want to spray some Lysol as moldy smell from using Max AC & floor heat. When on Max AC, WHERE is system inhaling the cabin air from? I felt up under glove box.... .... is it just right and above tranny tunnel? Smaller opening than i thought? That grill on topof dash is ONLY exhaust, defrost , right? Never sucks cabin air IN, does it?
Sorry for amateur q's but i confused???
-
11-17-2016, 04:49 PM #5323
Dropped in ECM w Frost tune, put the front plate insert on w a touch up painted bird until I get hood n all gets painted, did the rear Pontiac lettering vinyl filling but they forgot the I, and did some touchup paint around car before winter to seal up a couple chips.
-
11-18-2016, 06:10 AM #5324
- Join Date
- Mar 2011
- Location
- fort myers,fl
- Age
- 74
- Posts
- 95
black- 1998 trans am convertible
HAD tune up with ngk tr5's, injector service done yesterday. need to bring car back to shop tho. slight delay when starting out, seems to be running rough, engine service light came on within ten miles. acceleration is worse than with old plugs.
-
11-18-2016, 09:07 AM #5325
- Join Date
- Feb 2009
- Location
- Florida Man Status Acheivement
- Posts
- 11,759
Navy Blue Metallic- 98 T/A w/ mods, 00 FBVert
check that the wires are seated at both the coil and plug, at times they are a PITA to get on.
Just hope they didn't crack a plug.
-
11-19-2016, 06:06 AM #5326
- Join Date
- Mar 2011
- Location
- fort myers,fl
- Age
- 74
- Posts
- 95
black- 1998 trans am convertible
will do. this was the problem i had with last tune some 98k miles ago. surprisingly they said there was no oil fouling on the plugs!
-
11-19-2016, 08:42 AM #5327
- Join Date
- Apr 2011
- Location
- Johnstown,PA
- Age
- 54
- Posts
- 1,104
Silver- 1999 Trans-Am, 2012 Sonic
99 Trans Am, SLP Lid, Blackwing filter, smooth bellow, Ported TB, LS6 intake, Ws6 lower ram air box, OBX LT's, Magna Flow cat back, LS7 clutch, Tick MC, Hurst Shifter, Frost Tune, UMI SFC,LAC, STB, PB, Torq Arm, Super Hawk hood, Torq Thrust II, Kee Audio.
Strange S60 4:10's, D&S Rotors, S/S Brake Lines.
Nitto NT05R Track Tire's, 12.7 @ 108 / 1.82 60'
Wish list.
Coil overs, Heads & Cam
-
11-19-2016, 08:45 AM #5328
- Join Date
- Sep 2010
- Location
- Bel Air, Maryland
- Posts
- 1,675
Silver- '02 Trans Am WS-6, 6M
Had to get a new remote for the car, the old ones case insides speedster from the. Awe, and wouldn't work, and opening the car with they key every time would be annoying with the alarm going off everytime. Just let the dealer do it cause I didn't feel like messing with it and I was there anyways to buy the part.
Getting the oil changed today, would've just had the dealer do it but didn't bring the synthetic oil and filter with me.SLP Air Lid/Smooth Bellows
L76 6.0L block, PRC Ported 243 heads, Texas Speed 224R cam.
Kooks Emissions LT Headers/Catted Y pipe
NGK TR55 plugs
Magnaflow Cat-back
Spohn Front Upper Tubular Control Arms
UMI Front Lower Tubular Control Arms
UMI Front Sway Bar
UMI Rear Lower Control Arms/ Adjustable Panhard Rod
UMI Welded-on Two Piece Subframe Connectors
Factory C5 Z06 17x9.5 wheels w/ 285-40-17 Continental Extreme Contact Sports all the way around.
Dyno Dynamics dynoed @:
415 rwhp
-
11-19-2016, 08:49 AM #5329
-
11-20-2016, 04:28 AM #5330
- Join Date
- Jul 2009
- Location
- Albertville, Alabama, United S
- Posts
- 21
black- 1998 ws6 trans-am
went out and cranked it, running great but can't drive it needs a repair or replace rear-end having to save up, put cover back on it. the end for now!
Firewolf ( All My Children Have 4 Paws ) or 4 wheels
-
11-30-2016, 06:51 AM #5331
- Join Date
- Feb 2009
- Location
- Florida Man Status Acheivement
- Posts
- 11,759
Navy Blue Metallic- 98 T/A w/ mods, 00 FBVert
Early Christmas present ordered today.
New complete carpet from Yearone.http://www.ls1.com/forums/f7/my-6-liter-build-174257/
http://www.ls1.com/forums/f8/my-8-8-rear-build-165553/
6.0L Block - Forged 403ci , Polluter Stg3 Cam, FAST 102mm Intake, NW102 TB, MSD wires, NGK TR6 plugs, Truck Coil Packs, LS3 Fuel Injectors, CC Pacesetter LT Headers, TS&P ORY, QTP e-Cutout, Magnaflow Muffler, 104mm Air Lid & Line Lock, Catch Can, Stage 2 T56 w/Viper shaft, PRO 5.0 Shifter, Tick MC, SPEC Stg3+ Clutch, QT SFI BH, MWC DSL, Full UMI Performance Suspension, Belstein Shocks, Hotchkis Springs (1" Drop), YR1 Snowflake Wheels wrapped in NT555 tires & Custom Fab Ford 8.8 rear w/Wavetrac Diff 3.73 Yukon Gears, WSQ Hood, 3"CM Strange Eng Drive Shaft.
00 FB Vert - Stock
78 FB - Just getting started......
Horsepower never lies, but is often lied about!
-
11-30-2016, 07:05 AM #5332
Noticed DR headlight is out so thinking to buy the LMC ones. Seems to best bang for the buck with replaceable bulbs.
2001 Trans Am Vert
-
11-30-2016, 07:32 AM #5333
- Join Date
- Feb 2009
- Location
- Florida Man Status Acheivement
- Posts
- 11,759
Navy Blue Metallic- 98 T/A w/ mods, 00 FBVert
I've done the swap over to HID bulbs using LMC housings. I've made a how to thread if you need some assistance on what to buy and how to install.
-
11-30-2016, 07:40 AM #5334
I have 5 or 6 HID set-ups in the garage actually. I think 2 or 3 are 9006 and one 9005 and then some H1s from another project. I think all I really need are the housing. My truck has projectors that do not play well with HID so i wasted some money, but now it might get some use.
Just wish i could find a free shipping thing cause for some reason paying the $13.65 shipping just bugs me. (I think I am spoiled by Prime free shipping) Still seems to be the best deal going though and I think I like them better than Hawks housings that are basically same price.
As far as my research has gone it seems the housing are plug n play and the HID addition is just like any other.
I am looking at these though as well to upgrade the fogs to match better...
https://www.amazon.com/gp/product/B0...A2L77EE7U53NWQ
from a simple dead headlight to a $125 spent...damn
-
11-30-2016, 08:01 AM #5335
- Join Date
- Feb 2009
- Location
- Florida Man Status Acheivement
- Posts
- 11,759
Navy Blue Metallic- 98 T/A w/ mods, 00 FBVert
Yeah it snowballed on me as well.
I have no regrets though. I can see much better and most times I don't even need to turn my high beams on .
I have read that some ppl complain about HID in fog. That they don't penetrate far enough. I'll see when we start getting fog in the winter/spring.
I also notice one more extra bonus with the HID's.
Any reflector material within range shines like a beacon. I mean literally any like say some that might be on particular city/county/state vehicles with Blue lights that might be hiding on the side of the road.
-
11-30-2016, 08:18 AM #5336
I have ran HID on my truck since 09. It is more the color temp causing the reflection than HID. I swapped to LED on it with current setup and it is crazy how they make reflective signs glow, esp with the roof bar. Far past its usable light will still leave signs glowing.
The fog is the same thing the lower 3000-yellow to stock 4300 is less reflective to the fog and penetrates better.
I am thinking to go with the LED replacement fogs for the price and I have similar on truck...not to be used around traffic, but badass on backroads. Then do the LMC lows with a 5000K HID since over that decreases usable light. Also, I will likely just forget changing highs for now and leave the Sylvania stock replacements in there since I dont think they will be needed anyway and I hate to drop another 70 plus the cost of some LED since HID highs kinda suck with warm up time.
What color temp did you go with?
-
11-30-2016, 08:20 AM #5337
- Join Date
- Feb 2009
- Location
- Florida Man Status Acheivement
- Posts
- 11,759
Navy Blue Metallic- 98 T/A w/ mods, 00 FBVert
I'm using 8000k
-
11-30-2016, 08:22 AM #5338
I have found most LED seem to be in that 6-8 range. I do like the more blue look to em. The good thing is once you have the HID setup it is dirt cheap for a pair of bulbs to swap in and change color temps.
-
11-30-2016, 09:04 AM #5339
We just avoid driving our car after dark... cheapest fix ever!
-
11-30-2016, 09:06 AM #5340
I wish I could but its 65 miles in the dark to work and 65 in the dark home this time of year.
Looking at some more threads and i think this will be quite an improvement.
Thread Information
Users Browsing this Thread
There are currently 6 users browsing this thread. (0 members and 6 guests)
Similar Threads
-
new guy just got my first trans am today
By roger_johnson2002 in forum New Member IntroductionsReplies: 9Last Post: 07-14-2011, 08:35 AM -
Found this on the windshield of my Trans Am today
By ls1camino in forum Almost Anything GoesReplies: 60Last Post: 03-10-2009, 12:11 PM -
Got into an accident in the Trans Am today
By ls1camino in forum Almost Anything GoesReplies: 30Last Post: 09-21-2008, 04:32 PM -
Just got my Trans Am today!
By vannatte in forum Firebird / WS6Replies: 34Last Post: 09-20-2007, 09:57 AM -
First time at Track today!!! 2000 Trans Am ws6
By gimmeadonut in forum Drag RacingReplies: 1Last Post: 11-12-2005, 01:34 PM
Bookmarks