Results 3,921 to 3,940 of 7102
-
03-12-2015, 08:23 PM #3921
- Join Date
- Nov 2014
- Location
- near Fort Hood, TX
- Posts
- 412
blue- 2002 Trans Am
Well mine got done a little after midnight, so guess you could count it as today
Eibach Pro-Kit springs, Bilstein HD shocks, BMR rear sway bar with bolt on mounts
ASh
-
03-14-2015, 05:37 PM #3922
- Join Date
- Apr 2011
- Location
- Johnstown,PA
- Age
- 54
- Posts
- 1,104
Silver- 1999 Trans-Am, 2012 Sonic
Fabed this up today out of some scrap I had laying around to help with painting and install
And prepped it for paint tomorrow
-
03-14-2015, 07:11 PM #3923
- Join Date
- Nov 2014
- Location
- near Fort Hood, TX
- Posts
- 412
blue- 2002 Trans Am
very nice, I need to get my covered with plasti dip or something, I just didn't get it painted when I order it, wish I would have, but need to crawl under there and do something its getting covered by rust chite and I'm not liking it
ASh
-
03-15-2015, 01:32 PM #3924
- Join Date
- Apr 2011
- Location
- Johnstown,PA
- Age
- 54
- Posts
- 1,104
Silver- 1999 Trans-Am, 2012 Sonic
Painting complete except for rear cover.
-
03-15-2015, 03:31 PM #3925
I was able to go see our car Friday evening for a few minutes. So far, that's the highlight of 2015 for our Trans Am.
-
03-16-2015, 03:21 AM #3926
I hear ya pajeff02 . Its like you went through a bad divorce and you only get to see your baby on nice sunny days. I hate winter!!
-
03-16-2015, 03:24 AM #3927
- Join Date
- Nov 2014
- Location
- near Fort Hood, TX
- Posts
- 412
blue- 2002 Trans Am
Love the driveshaft
ASh
-
03-16-2015, 03:25 AM #3928
- Join Date
- Nov 2014
- Location
- near Fort Hood, TX
- Posts
- 412
blue- 2002 Trans Am
2002 auto T/A custom blue, Moser 9in rear end with 31 spline axle and 3.73 gears, Diablo Sport InTune, SLP LM1 catback, SLP lid & bellow, ram air free mod, eibach pro kit springs, bilstein hd shocks, bmr rear sway bar, bmr 2pt SFC bolt on, silver checker stripes 17x9.5 C5 Vette rims.
-
03-16-2015, 06:00 AM #3929
- Join Date
- May 2013
- Location
- Nashville, TN
- Posts
- 1,434
Black / White- '00 T/A M6/'19 Hemi Truck
New brakes are going on as I type this
2000 Black TA M6 - LT's, ORY, UMI Short Stick, TT2's, Drilled/Slotted Rotors, Braided Lines, and Tuned by Vengeance SCCA and Car Show Approved
2019 Ram 1500 Crew Cab Laramie Limited
2015 Ram 1500 Crew Cab Sport Premium Hemi - Sold
2010 Hemi Crew Cab Sport Premium - Tuner and HID's - Sold
06 Quad Cab HHHHemi - Sold
99 Hugger Orange Camaro - Sold
97 Camaro - Sold
-
03-17-2015, 04:58 AM #3930
- Join Date
- May 2013
- Location
- Nashville, TN
- Posts
- 1,434
Black / White- '00 T/A M6/'19 Hemi Truck
FINALLY...My brakes are installed. After the break in period I may or may not have taken an off ramp doing 105 to test them...car almost turned a flip when I put the peddle down to the floor. I'm extremely happy to say the least. Cannot wait to put the Hawk HP Plus pads on and hit a small road course to see what it'll really do
dont worry about that hex screw that I didnt put in yet......
-
03-17-2015, 11:53 AM #3931
- Join Date
- Apr 2011
- Location
- Johnstown,PA
- Age
- 54
- Posts
- 1,104
Silver- 1999 Trans-Am, 2012 Sonic
Refresh, what rotors did you use again.
-
03-17-2015, 01:30 PM #3932
Yea !!! FINALLY, warm and nice enough to take the T/A out for a spin...actually drove to a body shop to see about getting my new ( used) sail panel painted. Felt so good !! I'll be getting after those new rotors, pads and brake lines soon now that my garage is warm enough to actually spend more than 15 mins in. Come on April!! March is just a little too iffy around here for me.
-
03-17-2015, 03:37 PM #3933
- Join Date
- Apr 2011
- Location
- Johnstown,PA
- Age
- 54
- Posts
- 1,104
Silver- 1999 Trans-Am, 2012 Sonic
Almost there
And Done
-
03-17-2015, 03:47 PM #3934
Looking good!
-
03-17-2015, 05:12 PM #3935
- Join Date
- Aug 2007
- Location
- Greensboro, NC
- Age
- 39
- Posts
- 1,335
Pewter- 2002 Trans Am WS6 M6
Looking good. The between the clutch and rear end the break in driving is killing me. Just wanna floor it and see what she does.
Mods - Lid, Skip Shift Eliminator, MGW shifter, UMI SFCs, Founders Lower Control Arms, Founders Panhard Bar, Founders Adj. Torque Arm, UMI Torque arm mount, MWC Drive shaft safety loop, KONI Yellows, Strano Springs, Strano Sway bars, UMI Upper and lower A Arms, 160 thermostat, TSP headers and TSP true duals Monster stage 2 clutch, racetronix fuel pump, Strange S60 rear axle and tune by Frost.
-
03-17-2015, 06:09 PM #3936
-
03-18-2015, 03:45 AM #39371998 Pontiac TA, stock heads, FAST 90, FAST 90 TB, FLP LT, off road y-pipe with cat delete, flow master muffler, comp cams 54-457-11 223/231-610/617-112 LSA, Pro charger D1SC with FMIC @ 8psi, FROST tune, VIG 3200 stall, built 4l60e, snow meth kit, MOSER 12 bolt 373 gears, Derale 13900 trans cooler.
-
03-18-2015, 07:59 AM #3938
I changed out the bolts on ours in favor of stainless a while back.
-
03-18-2015, 08:45 AM #3939
- Join Date
- Nov 2014
- Location
- near Fort Hood, TX
- Posts
- 412
blue- 2002 Trans Am
-
03-18-2015, 11:26 AM #3940
Thread Information
Users Browsing this Thread
There are currently 7 users browsing this thread. (0 members and 7 guests)
Similar Threads
-
new guy just got my first trans am today
By roger_johnson2002 in forum New Member IntroductionsReplies: 9Last Post: 07-14-2011, 08:35 AM -
Found this on the windshield of my Trans Am today
By ls1camino in forum Almost Anything GoesReplies: 60Last Post: 03-10-2009, 12:11 PM -
Got into an accident in the Trans Am today
By ls1camino in forum Almost Anything GoesReplies: 30Last Post: 09-21-2008, 04:32 PM -
Just got my Trans Am today!
By vannatte in forum Firebird / WS6Replies: 34Last Post: 09-20-2007, 09:57 AM -
First time at Track today!!! 2000 Trans Am ws6
By gimmeadonut in forum Drag RacingReplies: 1Last Post: 11-12-2005, 01:34 PM
Bookmarks