Just installed B-quiet ultimate in the TA. There is definitely a noticeable difference in the acoustic level inside. I would recommend this to anyone that thinks that the inside is too loud.
Printable View
Just installed B-quiet ultimate in the TA. There is definitely a noticeable difference in the acoustic level inside. I would recommend this to anyone that thinks that the inside is too loud.
I did my Camaro with it and very pleased with the results as well. Seems so similar to Dynamat but much much cheaper.
How much does it weigh? and how much did you put in?
B-Quiet Ultimate is 1.6mm (60mil) thick, weighs 0.35 lb/sq. ft. comes in 1 foot wide rolls and is available in 2 sizes - 12 and 50 sq. ft. rolls
From their website it says a 12 sq ft roll is $55 and a 50 sq ft roll is $130/$120 if you buy 2 rolls.
I used a 50 sq roll for the whole floors front and rear and rear quarters.
The 2nd 50 sq roll is for my doors, you may be able to do the doors with a 12 and a 50 but its going to be close if you plan to do rear quarters. Or just buy 2 50's and have left over for other uses. No I do not have anything to do with this company or product. Just shopped around and this stuff seems so similar to Dynamat and much much cheaper.
is it harder than dynamat to install
I never used Dynomat but installing B-Quite was easy. Just cut it to size, remove the backing and place where you want and press it down all over.