installed a cut out on saturday and now I can't seem to close it ;) also brought her to school today
Printable View
installed a cut out on saturday and now I can't seem to close it ;) also brought her to school today
Fixed the passenger seat belt guide. Installed the new DRL housings and sockets. greased my roto joints.
The DRL housings were easy but the cheap soft ass screws used by GM snapped off on the inner hole... both housings!!!! so i mounted them with just the one for now. soft metal soft plastic tight fit.... didn't feel like fiddling with anything in the dark but i think they might shake a bit without the two holding them in place. Can't believe it happened on both of em.... ugh.
Pulled the fuses for my headlights. I could have gone for the wink look but that's just weird. I'll leave em like that till i get a chance to pull the motors and install the aluminum gears I have sitting at home.
Watched coolant leak out of it
Gonna drive her today!
First oil change since the rebuild, and adjusted the exhaust that was hanging low. Going for an alignment and emissions next week:xfingers:
I did this on the way to work (just without a video filming) [ame]http://www.youtube.com/watch?v=G0Ederey7TE[/ame]
Put Trans Am decals on my FRC's. I didn't do the best job filling in and painting them so these decals will help distract from that fact. Hopefully...
http://i232.photobucket.com/albums/e...f/TAENGBAY.jpg
changed my bad tranny mount (technically yesterday)
http://i106.photobucket.com/albums/m...r/IMG_0179.jpg
I've got an oil change coming up. I'm gonna pull the DMH cutout off at the same time and see if I can fix the rattling soming from it.
deleted secondary air system.much cleaner under the hood!
Posted via Mobile Device
Hopefully someone can find it. I used a write up to do mine but I'm out of town so won't have good access until Saturday. It's easy to do and cleans up your engine bay.
I put my chrome power steering cover on. It arrived today.
:yup: Relocating Cruise Module