Results 1 to 3 of 3

Time to start NEW MOTOR

This is a discussion on Time to start NEW MOTOR within the Computer & Tuning forums, part of the LSx Technical Help Section category; I just finished the install of my new 408 and I was wondering if there is anything special I need ...

  1. #1
    Stroked Slowmaro
    Join Date
    Sep 2005
    Location
    East Tennessee
    Posts
    66

    Silver
    2000 Z/28

    Time to start NEW MOTOR

    I just finished the install of my new 408 and I was wondering if there is anything special I need to do to the computer system before I start it. This is my first engine swap in a fuel injected car and Im not sure if I need to do any thing after I put the battery in. I was thinking put the battery in and crank it. I sent Texas Speed my computer and they set it up for 36lb injectors so I wouldnt wash the rings out. They said I could break the motor in and drive it around until I get a real tune. Any response would be appreciated.

  2. #2
    Senior Member mrr23's Avatar
    Join Date
    Jul 2005
    Location
    orlando, fl
    Posts
    7,134

    dark bowling green
    2000 corvette

    did they set the PCM up for your 408, or only change the injector sizing?

  3. #3
    Stroked Slowmaro
    Join Date
    Sep 2005
    Location
    East Tennessee
    Posts
    66

    Silver
    2000 Z/28

    Yes. They built the short block. I was too scared
    EastTNZ28

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Time to start...
    By SilentTrouble in forum General Help
    Replies: 0
    Last Post: 08-19-2010, 12:38 PM
  2. Help: wont start all the time !!!
    By batmanls1 in forum General Help
    Replies: 2
    Last Post: 03-18-2010, 08:02 PM
  3. motor turns over, but won't start... sometimes
    By Fueled in forum General Help
    Replies: 5
    Last Post: 01-19-2009, 10:09 AM
  4. New motor,new parts,no start.Need diagnostic...
    By always faster in forum LT1
    Replies: 2
    Last Post: 05-05-2007, 07:33 PM
  5. Time to start rebuilding....
    By DrMilhouse in forum Stereo and Electronics
    Replies: 3
    Last Post: 07-28-2006, 10:06 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •