This is a discussion on Please Help!!!!! within the Computer & Tuning forums, part of the LSx Technical Help Section category; I have a 99 hawk that i'm trying to get inspected, and i'm having trouble with it. I replaced the ...
08-18-2006, 07:14 PM #1
I have a 99 hawk that i'm trying to get inspected, and i'm having trouble with it. I replaced the o2 sensors with sims and had the ses light cleared. Now the engine doesn't hold a solid idle and acts like it wants to stall out and die. Also the ses light came back on with the same trouble codes that there was something wrong with the o2 sensor which i don't see how that could be possible being as how i have sims on there. What could be the cause of this and what can i do to fix it?
08-19-2006, 10:18 AM #2
Ok so you replaced the rear 02 sensors wit sims right? Make sure your front wires arent melted anywhere, What codes are you throwing?
J2001 SS, Its not the car its the Driver that matters....
08-21-2006, 12:35 AM #3
I was just having the ses code corrected out. I started up the engine the next day and popped the hood and heard this sucking sound from the airbox. just before that happens, the engine sounds like it's going to stall out and then it grabs some air and revs up and the sucking sound is gone. then a few seconds later, it happens again. I'm taking it into a pontiac dealer in the morn, but if you can give me some input so as that the dealer doesn't try to rob me, that would be super awsome.
08-21-2006, 03:04 PM #4
Hmm thats odd, So again you put 02 sims in the rear only correct?
08-21-2006, 09:22 PM #5
Yeah, both of the rear sensors located after the cat. i put sims of both of them. And plus the big problem is that my car doesn't want to breathe.
08-22-2006, 01:51 AM #6
What mods have you done ? in what order ?
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)