LQ4 Pinout question (Fuel Enable- circuit 229)

[tooblue]

I have the pinouts for the PCM but I can not find or see the pin for the fuel enable signal?
Did a search and can find it on the LS1 2002 (red 30, circuit 229) But looking at the pinouts for the truck PCM (the copy I have) it does not show a fuel enable or a circuit 229 ?? I was going to build the circuit as a temp solution until I get car to a place for programing or ship PCM off. Just got it fired up this weekend and runs for about 2-4 seconds. Wanted to get it to run longer so I could do some checks,, Leaks,,tranny goes ingear ,,ETC... Anyone have A suggestion let me know THANKS ,, Roger,,

[wait4me]

These have serial vats, you have to pull the vats off in the computer to let it work.
if the pcm was a pwm you could make up a signal, but it is pretty cheap to get it deleted from your system.