Results 1 to 7 of 7

Car won't start! Help?

This is a discussion on Car won't start! Help? within the Computer & Tuning forums, part of the LSx Technical Help Section category; I have an 06 GTO M6, That I just installed pacesetter ceramic coated LTs and off-road mid-pipes, I took the ...

  1. #1
    Member 05gtoautoX's Avatar
    Join Date
    Jan 2006
    Location
    riverton
    Posts
    556

    Impulse Blue
    2006 Pontiac G.T.O.

    Car won't start! Help?

    I have an 06 GTO M6, That I just installed pacesetter ceramic coated LTs and off-road mid-pipes, I took the car to my dads shop about 250 miles away to do this(he had a lift) and was told by a reputable tuner it would be fine to drive untuned after the install atleast this far(back home to get tuned), well all was good, it did have a CEL on but I expected that because of the lack of cats, I had driven maybe 200 miles and had to stop at a rest area for my daughter, turned the car off and it never started again, the headlights/tail lights come on, along with the dome and door lights, but none of the guage lights, message panel, seats don't move, trunk won't pop, horn don't work and doors won't lock, and if you try and lock the doors with the key F.O.B., the hazard lights come on and take about 2 minutes before they go off, all the fuses are good, battery is good, connections are good at battery and ECM, I've pulled the negative cable twice to try and "reset" it, hooked up my predator to it but says no trouble codes found, but I think it's due to the message panel having no power and NOT doing a system check. When you turn the key absolutely nothing happens, lights don't dim, no buzzers nothing. ANY HELP WOULD BE GREATLY APPRECIATED, Thanks.
    2006 impulse blue G.T.O
    Iron Block 408
    Cam
    Pacesetter ceramic coated L.T.s
    LMII exhaust
    K&N CAI
    Ported TB
    Custom Tune
    FAST 90
    ZEX 125hp wet shot

  2. #2
    SS#430 1 of 74 7camaro7's Avatar
    Join Date
    Oct 2005
    Location
    Nashville, TN
    Posts
    1,754

    Pewter
    02SS6spd VERT!

    I'd say DOUBLE check fuses. Do those GTOS have that pass key II like the fbodies? If so clean your key. I hope that works, I don't know what else to tell you.

  3. #3
    Veteran 0rion's Avatar
    Join Date
    Aug 2005
    Location
    ohio
    Posts
    22,520

    98 Formula
    06 duramax

    any chance a wire might've got fried by the headers?

  4. #4
    Member 05gtoautoX's Avatar
    Join Date
    Jan 2006
    Location
    riverton
    Posts
    556

    Impulse Blue
    2006 Pontiac G.T.O.

    I've double checked ALL the fuses and I don't think any wires were touching the headers, I looked preety good too, I took it to the dealership today they'll get it in tomorrow we'll see what they say, I'll keep you updated. Thanks

  5. #5
    Member 05gtoautoX's Avatar
    Join Date
    Jan 2006
    Location
    riverton
    Posts
    556

    Impulse Blue
    2006 Pontiac G.T.O.

    it was the ignition switch, shorted out and blew the fuse, it's all good now, runs like a champ.

  6. #6
    SS#430 1 of 74 7camaro7's Avatar
    Join Date
    Oct 2005
    Location
    Nashville, TN
    Posts
    1,754

    Pewter
    02SS6spd VERT!

    hahahaha, glad you found the problem

  7. #7
    Mustang/Rice Killer SnakeEatr's Avatar
    Join Date
    Jun 2007
    Location
    TOLEDO, OHIO
    Age
    31
    Posts
    133

    Electron Blue
    2001 Camaro Berger SS

    Talking

    amazingly simple now that we know what the problem was! :laugh:

    CAMARO. TRANS AM.
    TWO CARS, ONE MISSION............
    D O M I N A N C E !

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Help: 97 TA won't start
    By ADAM-00SS in forum LT1
    Replies: 7
    Last Post: 07-08-2010, 04:13 PM
  2. Z28 won't start
    By flaggs_ls1 in forum General Help
    Replies: 4
    Last Post: 05-11-2008, 09:46 PM
  3. where to start?
    By Jane_says in forum Firebird / WS6
    Replies: 47
    Last Post: 02-25-2007, 09:14 PM
  4. Cold Start/Warm Start Problem
    By I'mLS1John in forum General Help
    Replies: 11
    Last Post: 02-23-2007, 08:11 PM
  5. Cold Start/Warm Start Problem
    By I'mLS1John in forum New Member Introductions
    Replies: 0
    Last Post: 02-22-2007, 06:26 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •