ws6 u-joints

**johnfin** · 05-08-2018, 05:43 PM

I bought the recommended ac delco u-joints #89029292 but they look wimpy compared to the originals. They look a tad smaller too.
I am note going to hammer the car, just want to make sure they will fit ok.

**Redphoenix1998** · 05-09-2018, 08:23 AM

I had a situation with my driveshaft where the bearing on the driveshaft side was larger than the rear end side. Be sure to check the diameters when you install. But the Delco one's should be fine. The one that Strange sent me to install on a strange driveshaft to stock rearend was a Moog. I opted out of that one and just ordered a Spicer u-joint.

***SMWS6TA*** · 05-09-2018, 11:24 AM

I pretty much only use Moog U joints.

**Redphoenix1998** · 05-09-2018, 02:00 PM

Originally Posted by SMWS6TA

I pretty much only use Moog U joints.

I have no issue with Moog joints. The driveshaft was ordered with Spicer joints and I had a fitment issue. They sent me a new joint that was Moog and it fit but I personally opted for Spicer.