Results 1 to 7 of 7
Thread: What can I do with this?
-
01-18-2008, 03:05 PM #1
- Join Date
- Dec 2005
- Location
- Laurel, Maryland
- Posts
- 4,975
2000 Grand Prix GTP- 2000 Trans Am WS6 M6
What can I do with this?
I bought this third member today for $25, I don't know what the gear ratio is, nor do I know what it came out of (besides a Ford Truck). I am going to call the guy that sold it to me back tomorrow to figure out the specifics.
My question is, would this work with an F-Body? I'm going to call Moser tomorrow to talk to them about it, I just wanted your guys' opinion before I wasted my time with them.
Thanks.
-
01-18-2008, 07:35 PM #2
No it will not work
-
01-18-2008, 10:43 PM #3
-
01-19-2008, 10:16 AM #4
You are going to have to find a ford rear with that missing and it is going to have to be able to bolt up under your car. Good luck finding one.
Also, that thing is all rusted and the gears are shot. Your best bet is to take it to a swap meet and try to get more than $25 for it
-
01-21-2008, 08:12 AM #5
- Join Date
- Jun 2007
- Location
- Lathrop, Missouri
- Posts
- 2,482
NBM / Silver- 00 SS / 71 SS Elcamino
Any 9" ford third member will work in a moser case. I would have that one rebuilt with a 31 spline detroit trutrac, and new gears. You probly saved yourself $200-300 than buying new. Just be sure to match your posi unit splines to your axles. You can buy a moser case and axles for about 1k
2000 SS Camaro Heads, Large cam, Fast 90, 9"w/430's and locker, yada yada yada... you get the picture
1971 SS ElCamino 402 Big Block 550HP
2006 Silverado 2500HD 496 cubic inches of pure muscle
-
01-21-2008, 04:57 PM #6
good paper weights
-
01-24-2008, 09:59 AM #7
- Join Date
- Sep 2007
- Location
- AL
- Posts
- 74
Black- 2002 Camaro Z-28
That is a C7AW-E which is a low strength 28 spline third member. Came out of a vehicle post 1970 and has very little nodular iron content. Don't waste your money rebuilding that piece. What you want is a thrid member with a big "N" stamped on the front (stands for nodular iron) and has two verticle ribs. They are tought but not impossible to find in a junk yard, but folks know what they are so you are going to pay. Best bet is to buy a used N case on ebay and build it or just buy the Moser iron third member. You will have a tough time building a strong used N third member (with labor) for the price Moser sells theirs for.
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Bookmarks