Trouble with rear sway bar

**One_Bad_TA** · 03-22-2009, 06:45 PM

Hello I just got my Moser 9" in and the sway bar does not bolt on. The clamps that go around the axle housings on the rear but do not fit around the housing and sway bar. I tried some 3" exhaust clamps and they were not long enough. The C clamp fit around the housing fine but does not make it around the sway bar. I was looking at some leaf spring U bolts which are much longer and any excess I can just cut off. I was just wondering if anyone had any problems like this or any ideas to get this on? Thanks

**Bottesini** · 03-22-2009, 08:24 PM

The sway bars take some minor fabrication to get on. For mine I used the 3" muffler clamps and the stockers. What we had to do was cut the stock mounts open so that the holes for the u-bolt would fit. Than we used some thin aluminum strips to fill in the gap as needed, along with a few washers.

**One_Bad_TA** · 03-23-2009, 06:17 AM

Originally Posted by Bottesini

The sway bars take some minor fabrication to get on. For mine I used the 3" muffler clamps and the stockers. What we had to do was cut the stock mounts open so that the holes for the u-bolt would fit. Than we used some thin aluminum strips to fill in the gap as needed, along with a few washers.

Do you have any pics of this?