Results 1 to 1 of 1
-
04-24-2012, 03:00 PM #1
ram force 9.5 clutch not disengaging
i put a new ram force 9.5 dual diac set up in my 00 camaro and it wont fully disengage i though it was air in the system but i reinstalled the old clutch and it works fine. they sent a worksheet with the clutch to establish the rt preload and i fall within rams spec. Does anyone have any ideas or run into this with theirs?
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Question: T56 Clutch not disengaging after new clutch installed
By Brownsugar in forum Manual TransmissionReplies: 6Last Post: 09-25-2014, 04:15 AM -
Clutch not disengaging
By 1999sscamaro in forum Manual TransmissionReplies: 3Last Post: 04-13-2012, 05:34 PM -
Clutch not disengaging 100%?
By rossi1369 in forum Manual TransmissionReplies: 4Last Post: 04-25-2011, 07:57 PM -
Clutch Not Fully Disengaging (Spec 3+)
By bg552 in forum DrivetrainReplies: 1Last Post: 10-15-2007, 06:55 PM -
Transmission disengaging
By dixonk in forum Manual TransmissionReplies: 2Last Post: 05-19-2006, 07:03 AM
Bookmarks