Driveshaft busted...

**Ws6 Love** · 02-27-2007, 05:47 PM

So i went out to the test and tune on sat at sacramento raceway last sat and i got in a few runs and when i went to go do a burnout i heard a loud crashin noise, and i looked under and my driveshaft was just hangin down.. it wasnt even broken at the weld, it looked like it was machined cut and then polished off.. so im looking for an aftermarket one, i go with 3" or a 3.5? aluminum? and 33 spline? any help would be great

**Ws6 Love** · 03-01-2007, 04:50 PM

anyone? i actually plan on getting a 12 bolt, was there any bad things about buying one of these? should i be getting 33 spline since im 6spd?

**Hot Black Trans-Am** · 03-01-2007, 04:52 PM

My plans are a S60 with a CF shaft. Most likely over kill, but that's me!

**Ws6 Love** · 03-01-2007, 04:54 PM

i heard the 12 bolt is noisey tho, is that true? i would get a ford 9 but i want TCS

**Hot Black Trans-Am** · 03-01-2007, 05:19 PM

If your car isn't louder than your rear you need new exhaust!

**Ws6 Love** · 03-01-2007, 05:35 PM

well im really thinkin about geting the 12bolt, i should be getting 4 channel for TCS and 33 spline if im 6spd right?

**INMY01TA** · 03-03-2007, 11:24 PM

Did the same thing to mine. Replaced it with a steel on from A-1 (local to me). I got a Strange 12 bolt, 33 spline with 4:10's, and a Mcleod kevlar clutch. Makes for a good set up. My car only sees maybe 12-15 passes a year tho. For an m6 car if your gonna race more than that, you may want a 9 inch. Look at Spohn's site, they sell Strange chromemoly drive shafts in the $300ish range.