Results 1 to 3 of 3
Thread: Bad throw out bearing
-
10-19-2014, 06:17 AM #1
- Join Date
- Jun 2014
- Location
- Connecticut
- Posts
- 71
Black- 99 Trans Am WS6
Bad throw out bearing
So my throw out bearing went yesterday and I might as well do the whole clutch so I was wondering what you guys recommend for a clutch for my 6spd. She's just a cruiser, I don't race it so I don't need a race clutch in it and I don't want Something to expensive but I don't want a cheap clutch either. Looking for something right there in the middle that's reliable. Thanks
-
10-19-2014, 06:54 AM #2
- Join Date
- Aug 2007
- Location
- Greensboro, NC
- Age
- 39
- Posts
- 1,335
Pewter- 2002 Trans Am WS6 M6
The LS7 clutch is a nice stock style replacement and if you really dont plan on upgrading too much it's pretty good. If you want something stronger without getting too expensive the monster clutch line is the way to go. Quality is there and monster has a great warranty service.
If you haven't already go ahead and replace the clutch master cylinder with a tick performance one while your at it. Your clutch will last longer since it will fully disengage the clutch unlike the stock one. Plus it solves that pesky issue of clutch pedal sticking to the floor after hard shifting and if you ever have problems with 1st and reverse while sitting still it will help that too.Last edited by raynor139; 10-19-2014 at 06:56 AM.
Mods - Lid, Skip Shift Eliminator, MGW shifter, UMI SFCs, Founders Lower Control Arms, Founders Panhard Bar, Founders Adj. Torque Arm, UMI Torque arm mount, MWC Drive shaft safety loop, KONI Yellows, Strano Springs, Strano Sway bars, UMI Upper and lower A Arms, 160 thermostat, TSP headers and TSP true duals Monster stage 2 clutch, racetronix fuel pump, Strange S60 rear axle and tune by Frost.
-
10-19-2014, 06:45 PM #3
- Join Date
- Jun 2014
- Location
- Connecticut
- Posts
- 71
Black- 99 Trans Am WS6
Alright thanks
Thread Information
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
Similar Threads
-
Throw-out bearing or Pilot Bearing going out? Need help.
By werewolf in forum Manual TransmissionReplies: 3Last Post: 04-11-2013, 05:19 PM -
Throw out bearing about to pop!
By Z28er in forum Western MembersReplies: 0Last Post: 04-27-2010, 07:11 AM -
Throw out bearing question
By blk-ws6 in forum Manual TransmissionReplies: 6Last Post: 02-11-2010, 06:34 PM -
Throw-out bearing maybe?
By 98tranny in forum Manual TransmissionReplies: 4Last Post: 08-05-2008, 03:15 PM -
Does this sound like a bad throw out bearing?
By DarthD in forum Manual TransmissionReplies: 0Last Post: 04-17-2007, 11:20 PM
Bookmarks