This is a discussion on Help needed within the GM Trucks forums, part of the Vehicle Specific category; I recently acquired a relatively new LS1 motor from Turn Key Engine supplies as well as an LS1 from a ...
08-29-2007, 11:21 PM #1
- Join Date
- Aug 2007
- South Africa
I recently acquired a relatively new LS1 motor from Turn Key Engine supplies as well as an LS1 from a 1998 Camaro. The accessories on the Turnkey motor are similar to the Truck engine. My plan is to use the accessories (alternator, power steering pump, aircon waterpump etc) from the Turnkey engine on the Camaro block and visa versa. The problem is the pulley system on the Turnkey motor has a different offset from the motor (approximately 20mm further out) to the camaro motor. Ie. the crank pulleys have different offsets. the question is, can I simply remove both crank pulleys and swap them around with all the accessories or are the pulleys matched/balanced to a particular crank.
Any assistance will be appreciated.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By HiLL99SS in forum Forced InductionReplies: 58Last Post: 08-01-2013, 05:01 PM
By Phantomhp in forum Parts Wanted / TradeReplies: 0Last Post: 04-15-2007, 01:15 PM
By domestic rice in forum Sponsor FeedbackReplies: 0Last Post: 11-09-2006, 10:42 AM
By Michael Blue in forum Manual TransmissionReplies: 14Last Post: 04-04-2006, 12:08 PM
By ibanez7 in forum Parts Wanted / TradeReplies: 3Last Post: 03-10-2006, 07:20 PM