This is a discussion on Power loss within the Internal Engine forums, part of the LSx Technical Help Section category; Today, I noticed a considerable power loss following some braided steel line changes. The only thing I changed was the ...
10-19-2008, 03:34 PM #1
Today, I noticed a considerable power loss following some braided steel line changes. The only thing I changed was the vacuum line on the TB and pulled out the EGR to see about feasibility of doing that but, I put everything back.
I did clean the EGR sensor by just rubbing off the soot with a tee shirt. Did I fuck that up?
10-20-2008, 12:44 PM #2
Took it in today to have it looked at. No codes as of yet. It is not down shifting though so, any day now I should be getting some sort of check engine light and then I'll know more. Might be as simple as a solenoid and as expensive as a whole tranny depending on what the codes are.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Ed Blown Vert in forum Firebird / WS6Replies: 2Last Post: 08-28-2008, 09:17 AM
By Ed Blown Vert in forum Almost Anything GoesReplies: 0Last Post: 07-25-2008, 07:40 PM
By Ed Blown Vert in forum Almost Anything GoesReplies: 3Last Post: 06-02-2008, 05:51 AM
By Even10Flow in forum ConvertibleReplies: 5Last Post: 05-16-2007, 07:26 AM
By blackbird33 in forum General HelpReplies: 4Last Post: 03-23-2007, 09:28 PM