My H/C question.
This is a discussion on My H/C question. within the Internal Engine forums, part of the LSx Technical Help Section category; My trans swap fell through because ive been screwed over 3 times already so im spending the money elsewhere. Ill ...
06-23-2008, 01:33 PM #1
- Join Date
- Jun 2007
- Parma Heights, Ohio
- 99 Trans Am
My H/C question.
My trans swap fell through because ive been screwed over 3 times already so im spending the money elsewhere. Ill be ordering my H/C package when i get back from vacation, if all goes well.
PRC 2.5 5.3l ported heads
ported oil pump
My question is, i want to bump compression to 11 to 1. So what size head gaskets should i get? Also what size pushrods? Just to throw it out there, what do you think ill put down after its all installed? I was thinking about 420hp/400tq.
I also have an IAT high voltage code, does this mean that my car is pulling timing due to high IATs or this strictly electrical?
Last edited by Ryans99LS1; 06-23-2008 at 01:36 PM.99 TA-T56 swapped, Lid, TB Bypass, LS6 Intake, !EGR, !AIR, Custom Cam, Mids, O/R-Y, 3:73s, Cutout, Flowmaster.
A4 numbers w/ mids only 320RWHP 333RWTQ
Cam numbers and track times soon.
98 NBM Hardtop Formula- Bone stock, A4, 187,000 miles
13.8@ 103 2.1 60' 1357 DA
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By third_shift|studios in forum Kill StoriesReplies: 13Last Post: 05-13-2008, 01:57 PM
By claytonr in forum Forced InductionReplies: 2Last Post: 04-09-2008, 06:41 AM
By claytonr in forum Internal EngineReplies: 6Last Post: 04-08-2008, 08:39 AM
By 99Ls1fever in forum External EngineReplies: 5Last Post: 01-30-2008, 10:20 AM
By jinxeng in forum General HelpReplies: 4Last Post: 06-24-2006, 05:30 PM