Results 1 to 2 of 2

installing rollmaster in new short block

This is a discussion on installing rollmaster in new short block within the Internal Engine forums, part of the LSx Technical Help Section category; just got my new shortblock from tsp and when i went to install the crank gear it said it was ...

  1. #1
    Junior Member
    Join Date
    Aug 2005
    Location
    mo
    Age
    42
    Posts
    42

    hugger orange
    1999

    installing rollmaster in new short block

    just got my new shortblock from tsp and when i went to install the crank gear it said it was a 22 tooth gear but the instructions do not show a 22 tooth gear installation. do I just line up the crank key with the dot on the sprocket and install or what? any help is appreciated here!

  2. #2
    Senior Member mrr23's Avatar
    Join Date
    Jul 2005
    Location
    orlando, fl
    Posts
    7,134

    dark bowling green
    2000 corvette

    if there is only one keyway cut in the crank gear, it only goes on one way. then put the crank gear dot at 12:00 and the cam gear dot at 6:00

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. short block vs long block
    By askkmb in forum Internal Engine
    Replies: 3
    Last Post: 12-15-2012, 06:52 AM
  2. Question: short block vs long block
    By fbodyNATION in forum External Engine
    Replies: 4
    Last Post: 01-25-2011, 08:25 PM
  3. Installing Proform short throw shifter
    By flotty in forum General Help
    Replies: 4
    Last Post: 05-01-2010, 06:20 PM
  4. Long Block vs Short Block
    By ls1camino in forum Internal Engine
    Replies: 10
    Last Post: 09-08-2008, 09:54 AM
  5. noise after installing short throw
    By mockler in forum Manual Transmission
    Replies: 2
    Last Post: 07-08-2007, 05:12 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •